DS80PCI402 Datasheet, PDF (30/39 Pages) Texas Instruments – 2.5 Gbps / 5.0 Gbps / 8.0 Gbps 4 Lane PCI Express Repeater with Equalization and De-Emphasis

0x36
CH5 - CHA1
IDLE Threshold
0x39
CH6 - CHA2
IDLE, RXDET
0x3A
0x3B
CH6 - CHA2
EQ
CH6 - CHA2
VOD
7:4 Reserved
3:2 IDLE thd
1:0 IDLE tha
7:6 Reserved
5
IDLE_AUTO
4
IDLE_SEL
3:2 RXDET
1:0 Reserved
7:0 EQ Control
7
Short Circuit
Protection
6
RATE_SEL
5:3 Reserved
2:0 VOD Control
R/W 0x00
R/W 0x00
R/W 0x2F
R/W 0xAD
Set bits to 0.
De-assert threshold
00 = 110 mVp-p (default)
01 = 100 mVp-p
10 = 150 mVp-p
11 = 130 mVp-p
Note: override the SD_TH pin.
Assert threshold
00 = 180 mVp-p (default)
01 = 160 mVp-p
10 = 210 mVp-p
11 = 190 mVp-p
Note: override the SD_TH pin.
Set bits to 0.
1: Automatic IDLE detect
0: Allow IDLE_SEL control in bit 4
Note: override IDLE control.
1: Output is MUTED (electrical idle)
0: Output is ON
Note: override IDLE control.
00: Input is high-z impedance
01: Auto RX-Detect,
outputs test every 12 ms for 600 ms (50 times)
then stops; termination is high-z until detection;
once detected input termination is 50 Ω
10: Auto RX-Detect,
outputs test every 12 ms until detection occurs;
termination is high-z until detection; once
detected input termination is 50 Ω
11: Input is 50 Ω
Note: override RXDET pin.
Set bits to 0.
IA2 EQ Control - total of 256 levels.
See Table 2: Equalizer Settings.
1: Enable the short circuit protection
0: Disable the short circuit protection
1: Gen 1/2,
0: Gen 3
Note: override the RATE pin.
Set bits to default value - 101.
OA2 VOD Control
000: 0.7 V
001: 0.8 V
010: 0.9 V
011: 1.0 V
100: 1.1 V
101: 1.2 V (default)
110: 1.3 V
111: 1.4 V
www.ti.com
30