OPA314-Q1 Datasheet, PDF (21/38 Pages) Texas Instruments – 3-MHz, Low-Power, Low-Noise, RRIO, 1.8-V CMOS Operational Amplifier

www.ti.com
8 Application and Implementation
OPA314-Q1, OPA2314-Q1, OPA4314-Q1
SLOS896B – DECEMBER 2014 – REVISED JANUARY 2017
NOTE
Information in the following applications sections is not part of the TI component
specification, and TI does not warrant its accuracy or completeness. TI’s customers are
responsible for determining suitability of components for their purposes. Customers should
validate and test their design implementation to confirm system functionality.
8.1 Application Information
The OPAx314-Q1 family is a low-power, rail-to-rail input and output operational amplifier specifically designed for
portable applications. The device operates from 1.8 V to 5.5 V, is unity-gain stable, and suitable for a wide range
of general-purpose applications. The class AB output stage is capable of driving ≤ 10-kΩ loads connected to any
point between V+ and ground. The input common-mode voltage range includes both rails, and allows the
OPAx314-Q1 family to be used in virtually any single-supply application. Rail-to-rail input and output swing
significantly increases dynamic range, especially in low-supply applications, and makes the device ideal for
driving sampling analog-to-digital converters (ADCs).
The OPAx314-Q1 family features a 3-MHz bandwidth and 1.5-V/μs slew rate with only 150-μA supply current per
channel, providing good AC performance at very low power consumption. DC applications are also well served
with a very-low input noise voltage of 14 nV/√Hz at 1 kHz, low-input bias current (0.2 pA), and an input offset
voltage of 0.5 mV (typical).
8.1.1 General Configurations
When receiving low-level signals, limiting the bandwidth of the incoming signals into the system is often required.
The simplest way to establish this limited bandwidth is to place an RC filter at the noninverting terminal of the
amplifier, as shown in Figure 34.
R_G
R_F
R₁
V_IN
V_OUT
C₁
f_{-3 dB} =
1
2pR₁C₁
( ( ^VOUT
V_IN
=
1
+
R_F
R_G
1
1 + sR₁C₁
Figure 34. Single-Pole Low-Pass Filter
If additional attenuation is needed, a multiple pole filter is required. The Sallen-Key filter can be used for this
task, as shown in Figure 35. For best results, the amplifier must have a bandwidth that is eight to ten times the
filter frequency bandwidth. Failure to follow this guideline can result in phase shift of the amplifier.
Copyright © 2014–2017, Texas Instruments Incorporated
Submit Documentation Feedback
21
Product Folder Links: OPA314-Q1 OPA2314-Q1 OPA4314-Q1