SN74ALVCH374_16 Datasheet, PDF (2/17 Pages) Texas Instruments – OCTAL POSITIVE EDGE-TRIGGERED D-TYPE FLIP-FLOP WITH 3-STATE OUTPUTS

SN74ALVCH374
OCTAL POSITIVE EDGE-TRIGGERED D-TYPE FLIP-FLOP
WITH 3-STATE OUTPUTS
SCES118G – JULY 1997 – REVISED OCTOBER 2004
FUNCTION TABLE
INPUTS
OE
CLK
D
L
↑
H
L
↑
L
L
H or L
X
H
X
X
OUTPUT
Q
H
L
Q₀
Z
LOGIC DIAGRAM (POSITIVE LOGIC)
OE ¹
CLK ¹¹
3
1D
C1
1D
2
1Q
www.ti.com
To Seven Other Channels
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
over operating free-air temperature range (unless otherwise noted)
V_CC
Supply voltage range
V_I
Input voltage range⁽²⁾
V_O
Output voltage range⁽²⁾⁽³⁾
I_IK
Input clamp current
I_OK
Output clamp current
I_O
Continuous output current
Continuous current through V_CC or GND
θ_JA
Package thermal impedance⁽⁴⁾
T_stg
Storage temperature range
V_I < 0
V_O < 0
DB package
DGV package
DW package
N package
PW package
MIN
MAX UNIT
-0.5
4.6 V
-0.5
4.6 V
-0.5
V_CC + 0.5
V
-50 mA
-50 mA
±50 mA
±100 mA
70
92
58 °C/W
69
83
-65
150 °C
(1) Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating
conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) The input negative-voltage and output voltage ratings may be exceeded if the input and output current ratings are observed.
(3) This value is limited to 4.6 V maximum.
(4) The package thermal impedance is calculated in accordance with JESD 51-7.
2