BQ24740_14 Datasheet, PDF (18/33 Pages) Texas Instruments – Host-Controlled Multi-Chemistry Battery Charger

bq24740
SLUS736C – DECEMBER 2006 – REVISED MARCH 2009............................................................................................................................................... www.ti.com
I _ADAPTER
+
V_ACSET
V_VDAC
0.10
R_AC
(3)
The input voltage range of ACSET is between 0 and V_DAC, up to 3.6 V.
The ACP and ACN pins are used to sense R_AC with default value of 10mΩ. However, resistors of other values
can also be used. For a larger the sense resistor, you get a larger sense voltage, and a higher regulation
accuracy; but, at the expense of higher conduction loss.
ADAPTER DETECT AND POWER UP
An external resistor voltage divider attenuates the adapter voltage before it goes to ACDET. The adapter detect
threshold should typically be programmed to a value greater than the maximum battery voltage and lower than
the minimum allowed adapter voltage. The ACDET divider should be placed before the ACFET in order to sense
the true adapter input voltage whether the ACFET is on or off.
If PVCC is below 4 V, the device is disabled.
If ACDET is below 0.6 V but PVCC is above 4 V, part of the bias is enabled, including a crude bandgap
reference. IADAPT is disabled and pulled down to GND. The total quiescent current is less than 10 µA.
Once ACDET rises above 0.6 V and PVCC is above 4 V, all the bias circuits are enabled and REGN output goes
to 6 V and VREF goes to 3.3 V. IADAPT becomes valid to proportionally reflect the adapter current. The total
quiescent current is about 1 mA.
When ACDET keeps rising and passes 2.4 V, a valid ac adapter is present. 700ms later, the following occurs:
• EXTPWR becomes low through external pull-up resistor to the host digital voltage rail.
• Charging begins if all the conditions are satisfied, see the ENABLE AND DISABLE CHARGING section.
ENABLE AND DISABLE CHARGING
The following conditions have to be valid before charge is enabled:
• CHGEN is LOW;
• PVCC > UVLO;
• Adapter is detected;
• Adapter is higher than PVCC-BAT threshold;
• Adapter is not overvoltage;
• 700 ms delay is complete after adapter detected;
• REGNGOOD and VREFGOOD are valid;
• Thermal Shut (TSHUT) is not valid;
One of the following conditions will stop on-going charging:
• CHGEN is HIGH;
• PVCC < UVLO;
• Adapter is removed;
• Adapter is less than 185 mV above battery;
• Adapter is overvoltage;
• Adapter is overcurrent;
• TSHUT IC temperature threshold is reached (155°C on rising-edge with 20°C hysteresis).
AUTOMATIC INTERNAL SOFT-START CHARGER CURRENT
The charger automatically soft-starts the charger regulation current every time the charger is enabled to ensure
there is no overshoot or stress on the output capacitors or the power converter. The soft-start consists of
stepping-up the charge regulation current into 8 evenly divided steps up to the programmed charge current. Each
step lasts around 1.7 ms, for a typical rise time of 13.6 ms. No external components are needed for this function.
18
Submit Documentation Feedback
Product Folder Link(s) :bq24740
Copyright © 2006–2009, Texas Instruments Incorporated