AMC1303E0510 Datasheet, PDF (18/40 Pages) Texas Instruments – Small, High-Precision, Reinforced Isolated Delta-Sigma Modulators with Internal Clock

AMC1303E0510, AMC1303M0510, AMC1303E0520, AMC1303M0520
AMC1303E2510, AMC1303M2510, AMC1303E2520, AMC1303M2520
SBAS771 – JUNE 2017
www.ti.com
8.3 Feature Description
8.3.1 Analog Input
The AMC1303 incorporates a front-end circuitry that contains a differential amplifier and sampling stage, followed
by a ΔΣ modulator. The gain of the differential amplifier is set by internal precision resistors to a factor of 4 for
devices with a specified input voltage range of ±250 mV (for the AMC1303x25x), or to a factor of 20 in devices
with a ±50-mV input voltage range (for the AMC1303x05x), resulting in a differential input resistance of 4.9 kΩ
(for the AMC1303x05x) or 22 kΩ (for the AMC1303x25x).
For reduced offset and offset drift, the differential amplifier is chopper-stabilized with the switching frequency set
at f_CLK / 32. Figure 37 shows that the switching frequency generates a spur.
0
-20
-40
-60
-80
-100
-120
-140
-160
0.1
1
10
100
1000
10000
Frequency (kHz)
D007
AMC1303xxx20, sinc³ filter, OSR = 2, f_IN = 1 kHz
Figure 37. Quantization Noise Shaping
Consider the input resistance of the AMC1303 in designs with high-impedance signal sources that can cause
degradation of gain and offset specifications. The importance of this effect, however, depends on the desired
system performance. Additionally, the input bias current caused by the internal common-mode voltage at the
output of the differential amplifier causes an offset that is dependent on the actual amplitude of the input signal.
See the Isolated Voltage Sensing section for more details on reducing these effects.
There are two restrictions on the analog input signals (AINP and AINN). First, if the input voltage exceeds the
range AGND – 6 V to AVDD + 0.5 V, the input current must be limited to 10 mA because the device input
electrostatic discharge (ESD) diodes turn on. In addition, the linearity and noise performance of the device are
ensured only when the differential analog input voltage remains within the specified linear full-scale range (FSR),
that is ±250 mV (for the AMC1303x25x) or ±50 mV (for the AMC1303x05x), and within the specified input
common-mode voltage range.
18
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
Product Folder Links: AMC1303E0510 AMC1303M0510 AMC1303E0520 AMC1303M0520 AMC1303E2510
AMC1303M2510 AMC1303E2520 AMC1303M2520