SN74AUP1G06_10 Datasheet, PDF (8/21 Pages) Texas Instruments – LOW-POWER SINGLE INVERTER BUFFER/DRIVER WITH OPEN-DRAIN OUTPUTS

SN74AUP1G06
SCES590D – JULY 2004 – REVISED MAY 2010
PARAMETER MEASUREMENT INFORMATION
(Enable and Disable Times)
From Output
Under Test
C_L
(see Note A)
5 kW
5 kW
2 ´ V_CC
S1
GND
TEST
t_PLZ/t_PZL
t_PHZ/t_PZH
S1
2 ´ V_CC
GND
www.ti.com
LOAD CIRCUIT
V_CC = 0.8 V
V_CC = 1.2 V
± 0.1 V
V_CC = 1.5 V
± 0.1 V
V_CC = 1.8 V
± 0.15 V
V_CC = 2.5 V
± 0.2 V
V_CC = 3.3 V
± 0.3 V
C_L 5, 10, 15, 30 pF 5, 10, 15, 30 pF 5, 10, 15, 30 pF 5, 10, 15, 30 pF 5, 10, 15, 30 pF 5, 10, 15, 30 pF
V_M
V_CC/2
V_CC/2
V_CC/2
V_CC/2
V_CC/2
V_CC/2
V_I
V_CC
V_CC
V_CC
V_CC
V_CC
V_CC
V_D
0.1 V
0.1 V
0.1 V
0.15 V
0.15 V
0.3 V
Output
Control
V_CC/2
V_CC/2
Output ^tPZL
Waveform 1
S1 at 2 ´ V_CC
(see Note B)
t_PZH
Output
Waveform 2
S1 at GND
(see Note B)
V_CC/2
V_CC/2
t_PLZ
V_OL + V_D
t_PHZ
V_OH - V_D
VOLTAGE WAVEFORMS
ENABLE AND DISABLE TIMES
LOW- AND HIGH-LEVEL ENABLING
V_CC
0V
V_CC
V_OL
V_OH
»0 V
NOTES: A. C_L includes probe and jig capacitance.
B. Waveform 1 is for an output with internal conditions such that the output is low, except when disabled by the output control.
Waveform 2 is for an output with internal conditions such that the output is high, except when disabled by the output control.
C. All input pulses are supplied by generators having the following characteristics: PRR £ 10 MHz, Z_O = 50 W, t_r/t_f = 3 ns.
D. The outputs are measured one at a time, with one transition per measurement.
E. t_PLZ and t_PHZ are the same as t_dis.
F. t_PZL and t_PZH are the same as t_en.
G. All parameters and waveforms are not applicable to all devices.
Figure 4. Load Circuit and Voltage Waveforms
8
Submit Documentation Feedback
Copyright © 2004–2010, Texas Instruments Incorporated
Product Folder Link(s): SN74AUP1G06