CC1310_15 Datasheet, PDF (8/46 Pages) Texas Instruments – CC1310 SimpleLink Ultra-Low Power Sub-1 GHz Wireless MCU

CC1310
SWRS181A – SEPTEMBER 2015 – REVISED SEPTEMBER 2015
www.ti.com
5 Specifications
5.1 Absolute Maximum Ratings
over operating free-air temperature range (unless otherwise noted)⁽¹⁾⁽²⁾
VDDS⁽³⁾ Supply voltage
Voltage on any digital pin⁽⁴⁾
MIN
MAX
UNIT
–0.3
4.1
V
–0.3
VDDS + 0.3, max 4.1
V
Voltage on crystal oscillator pins, X32K_Q1, X32K_Q2, X24M_N and X24M_P
–0.3
VDDR + 0.3, max 2.25
V
Voltage scaling enabled
–0.3
VDDS
V_in
Voltage on ADC input Voltage scaling disabled, internal reference
Voltage scaling disabled, VDDS as reference
–0.3
1.49
V
–0.3
VDDS / 2.9
Input RF level
+10
dBm
T_stg
Storage temperature
–40
150
°C
(1) Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under Recommended Operating
Conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values are with respect to VDDS, unless otherwise noted.
(3) VDDS2 and VDDS3 must be at the same potential as VDDS.
(4) Including analog capable DIO.
5.2 ESD Ratings
V_ESD Electrostatic discharge
Human body model (HBM), per ANSI/ESDA/JEDEC JS001⁽¹⁾ All pins
Charged device model (CDM), per JESD22-C101⁽²⁾
All pins
(1) JEDEC document JEP155 states that 500-V HBM allows safe manufacturing with a standard ESD control process.
(2) JEDEC document JEP157 states that 250-V CDM allows safe manufacturing with a standard ESD control process.
VALUE
±3500
±1250
UNIT
V
5.3 Recommended Operating Conditions
over operating free-air temperature range (unless otherwise noted)
Ambient temperature
Operating supply voltage (VDDS)
Rising supply voltage slew rate
Falling supply voltage slew rate
Falling supply voltage slew rate, with low-power flash setting⁽¹⁾
Positive temperature gradient in standby⁽²⁾
For operation in battery-powered and 3.3-V
systems (internal DC-DC can be used to minimize
power consumption)
No limitation for negative temperature gradient, or
outside standby mode
MIN
MAX UNIT
–40
85
°C
1.8
3.8
V
0
100 mV/µs
0
20 mV/µs
3 mV/µs
5
°C/s
(1) For small coin-cell batteries, with high worst-case end-of-life equivalent source resistance, a 22-µF VDDS input capacitor must be used
to ensure compliance with this slew rate.
(2) Applications using RCOSC_LF as sleep timer must also consider the drift in frequency caused by a change in temperature (see
Section 5.10.3.4).
8
Specifications
Submit Documentation Feedback
Product Folder Links: CC1310
Copyright © 2015, Texas Instruments Incorporated