CC1310_15 Datasheet, PDF (27/46 Pages) Texas Instruments – CC1310 SimpleLink Ultra-Low Power Sub-1 GHz Wireless MCU

www.ti.com
CC1310
SWRS181A – SEPTEMBER 2015 – REVISED SEPTEMBER 2015
Table 6-1. GPIOs Connected to the Sensor Controller⁽¹⁾
ANALOG
CAPABLE
Y
Y
Y
Y
Y
Y
Y
Y
N
N
N
N
N
N
N
7-mm × 7-mm RGZ
DIO NUMBER
30
29
28
27
26
25
24
23
7
6
5
4
3
2
1
6.5 Memory
(1) Up to 15 pins can be connected to the Sensor Controller. Up to 8 of
these pins can be connected to analog modules.
The flash memory provides nonvolatile storage for code and data. The flash memory is in-system
programmable.
The SRAM (static RAM) is split into two 4-KB blocks and two 6-KB blocks and can be used for both
storage of data and execution of code. Retention of the RAM contents in standby mode can be enabled or
disabled individually for each block to minimize power consumption. In addition, if flash cache is disabled,
the 8-KB cache can be used as a general-purpose RAM.
The ROM provides preprogrammed, embedded TI RTOS kernel and Driverlib. It also contains a
bootloader that can be used to reprogram the device using SPI or UART.
6.6 Debug
The on-chip debug support is done through a dedicated cJTAG (IEEE 1149.7) or JTAG (IEEE 1149.1)
interface.
Copyright © 2015, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: CC1310
Detailed Description
27