AD1954YSTZ Datasheet, PDF (8/36 Pages) Analog Devices – SigmaDSP™ 3-Channel, 26-Bit Signal Processing DAC

AD1954–Typical Performance Characteristics
PERFORMANCE PLOTS
The following plots demonstrate the performance achieved on the
actual silicon. TPC 1 shows an FFT of a full-scale 1 kHz signal,
with a THD+N of –100 dB, which is dominated by a second
harmonic.TPC 2 shows an FFT of a –60 dB sine wave, demon-
strating the lack of low-level artifacts. TPC 3 shows a frequency
response plot with the seven equalization biquads set to an alter-
nating pattern of 6 dB boosts and cuts. TPC 4 shows a linearity
plot, where the measurement was taken with the same equalization
curve used to make TPC 3.When the biquad filters are not in use,
the signal passes through the filters with no quantization effects.
TPC 4 therefore demonstrates that using double-precision math
in the biquad filters has virtually eliminated any quantization
artifacts. TPC 5 shows a tone-burst applied to the compressor,
with the attack and recovery characteristics plainly visible. The
rms detector was programmed for normal rms time constants;
the hold/decay feature was not used for this plot.
0
–2
–4
–6
–8
–10
–12
–14
–16
–18
–20
20
50
100 200 500 1k 2k 5k
10k
Hz
TPC 3. Frequency Response of EQ Biquad Filters
0
–20
–40
–60
–80
–100
–120
–140
–160
0 2 4 6 8 10 12 14 16 18 20
kHz
TPC 1. FFT of Full-Scale Sine Wave (32k Points)
3.0
2.5
2.0
1.5
1.0
0.5
0
–0.5
–1.0
–1.5
–2.0
–2.5
–3.0
–120
–100
–80
–60
–40
–20
0
dBFS
TPC 4. Linearity Plot
0
–20
–40
–60
–80
–100
–120
–140
–160
0 2 4 6 8 10 12 14 16 18 20
kHz
TPC 2. FFT of –60 dB Sine Wave (32k Points)
2.0
1.5
1.0
0.5
0
–0.5
–1.0
–1.5
–2.0
–120
–100
–80
–60
–20
0
ms
TPC 5. Tone-Burst Response with Compressor
Threshold Set to –20 dB
–8–
REV. A