TLC227X Datasheet, PDF (5/64 Pages) Texas Instruments – Advanced LinCMOSE RAIL-TO-RAIL OPERATIONAL AMPLIFIERS

ą
TLC227x, TLC227xA
Advanced LinCMOS RAILĆTOĆRAIL
OPERATIONAL AMPLIFIERS
SLOS190G − FEBRUARY 1997 − REVISED MAY 2004
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)^†
Supply voltage, V_{DD +} (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 V
Supply voltage, V_{DD −} (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −8 V
Differential input voltage, V_ID (see Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 16 V
Input voltage range, V_I (any input, see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V_DD− − 0.3 V to V_DD+
Input current, I_I (any input) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 5 mA
Output current, I_O . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 50 mA
Total current into V_{DD +} . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 50 mA
Total current out of V_{DD −} . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 50 mA
Duration of short-circuit current at (or below) 25°C (see Note 3) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . unlimited
Package thermal impedance, θ_JA (see Notes 4 and 5): D package (8 pin) . . . . . . . . . . . . . . . . . . . . 97.1°C/W
D package (14 pin) . . . . . . . . . . . . . . . . . . . 86.2°C/W
N package . . . . . . . . . . . . . . . . . . . . . . . . . . 79.7°C/W
P package . . . . . . . . . . . . . . . . . . . . . . . . . . 84.6°C/W
PW package (8 pin) . . . . . . . . . . . . . . . . . . . 149°C/W
PW package (14 pin) . . . . . . . . . . . . . . . . . . 113°C/W
Package thermal impedance, θ_JC (see Notes 4 and 5): FK package . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.6°C/W
J package . . . . . . . . . . . . . . . . . . . . . . . . . . 15.1°C/W
U package . . . . . . . . . . . . . . . . . . . . . . . . . . 14.7°C/W
Operating free-air temperature range, T_A: C suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C to 70°C
I, Q suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −40°C to 125°C
M suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −55°C to 125°C
Storage temperature range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −65°C to 150°C
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds: D, N, P or PW package . . . . . . . . . . 260°C
Lead temperature 1,6 mm (1/16 inch) from case for 60 seconds: J or U package . . . . . . . . . . . . . . . . . 300°C
† _{Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and}
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltage values, except differential voltages, are with respect to the midpoint between VDD+ and VDD _−.
2. Differential voltages are at IN+ with respect to IN −. Excessive current will flow if input is brought below VDD _− − 0.3 V.
3. The output may be shorted to either supply. Temperature and/or supply voltages must be limited to ensure that the maximum
dissipation rating is not exceeded.
4. Maximum power dissipation is a function of TJ(max), θ_JA, and TA. The maximum allowable power dissipation at any allowable
ambient temperature is PD = (TJ(max) − TA)/θ_JA. Operating at the absolute maximum TJ of 150°C can affect reliability.
5. The package thermal impedance is calculated in accordance with JESD 51-7 (plastic) or MIL-STD-883 Method 1012 (ceramic).
recommended operating conditions
Supply voltage, VDD _±
Input voltage, VI
Common-mode input voltage, VIC
Operating free-air temperature, TA
C SUFFIX
I SUFFIX
Q SUFFIX
M SUFFIX
MIN
MAX
MIN
MAX
MIN
MAX
MIN
MAX
± 2.2
±8
± 2.2
±8
± 2.2
±8
± 2.2
±8
VDD _−
VDD _−
0
VDD ₊ − 1.5
VDD ₊ − 1.5
70
VDD _−
VDD _−
− 40
VDD ₊ − 1.5
VDD ₊ − 1.5
125
VDD _−
VDD _−
− 40
VDD ₊ − 1.5
VDD ₊ − 1.5
125
VDD _−
VDD _−
− 55
VDD ₊ − 1.5
VDD ₊ − 1.5
125
UNIT
V
V
V
°C
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
5