BQ24266_15 Datasheet, PDF (31/41 Pages) Texas Instruments – bq24266 3A, 30V Standalone Single-Input, Single-Cell Switchmode Li-Ion Battery Charger

www.ti.com
9 Power Supply Recommendations
bq24266
SLUSBY5F – JUNE 2014 – REVISED AUGUST 2015
9.1 Requirements for SYS Output
In order to provide an output voltage on SYS, the bq24266 requires either a power supply between 4.2 and 14 V
with at least 100 mA current rating connected to IN; or, a single-cell Li-Ion battery with voltage > VBATUVLO
connected to BAT. The source current rating needs to be at least 2.5 A in order for the buck converter of the
charger to provide maximum output power to SYS.
9.2 Requirements for Charging
In order for charging to occur the source voltage measured at the IN pins of the IC, factoring in cable/trace
losses from the source, must be greater than the VINDPM threshold, but less than the maximum values shown
above. The current rating of the source must be higher than the buck converter needs to provide the load on
SYS. For charging at a desired charge current of I_CHRG, V_IN x I_IN x η > V_SYS x (_ISYS+ I_CHRG) where η is the
efficiency estimate from Figure 2 or Figure 3 and VSYS = VBAT when VBAT charges above VMINSYS. The
charger limits I_IN to the current limit setting of that input. With ISYS = 0 A, the charger consumes maximum
power at the end of CC mode, when the voltage at the BAT pin is near VBATREG but ICHRG has not started to
taper off toward ITERM.
Copyright © 2014–2015, Texas Instruments Incorporated
Submit Documentation Feedback
31