THS4041 Datasheet, PDF (3/28 Pages) Texas Instruments – 165-MHz C-STABLE HIGH-SPEED AMPLIFIERS

THS4041, THS4042
165-MHz C-STABLE HIGH-SPEED AMPLIFIERS
SLOS237B– MAY 1999 – REVISED FEBRUARY 2000
DISSIPATION RATING TABLE
PACKAGE
θ_JA
(°C/W)
θ_JC
(°C/W)
TA = 25°C
POWER RATING
D
167†
38.3
740 mW
DGN‡
58.4
4.7
2.14 W
† _{This data was taken using the JEDEC standard Low-K test PCB. For the JEDEC proposed}
High-K test PCB, the θ_JA is 95°C/W with a power rating at TA = 25°C of 1.32 W.
‡ _{This data was taken using 2 oz. trace and copper pad that is soldered directly to a 3 in. × 3 in.}
PC. For further information, refer to Application Information section of this data sheet.
recommended operating conditions
Supply voltage, VCC+ and VCC–
Operating free-air temperature, TA
Dual supply
Single supply
C-suffix
I-suffix
MIN NOM MAX UNIT
±4.5
±16
V
9
32
0
70
°C
–40
85
electrical characteristics at T_A = 25°C, V_CC = ±15 V, R_L = 150 Ω (unless otherwise noted)
dynamic performance
PARAMETER
TEST CONDITIONS†
MIN TYP MAX
VCC = ±15 V Rf = 200 Ω
Gain = 1
165
Dynamic performance small-signal bandwidth ^{VCC = ±5 V}
Rf = 200 Ω
150
(–3 dB)
BW
Bandwidth for 0.1 dB flatness
VCC = ±15 V
Rf = 1.3 kΩ
Gain = 2
60
VCC = ±5 V
Rf = 1.3 kΩ
60
VCC = ±15 V Rf = 200 Ω
Gain = 1
45
VCC = ±5 V
Rf = 200 Ω
45
Full power bandwidth§
VO(pp) = 20 V,
VO(pp) = 5 V,
VCC = ±15 V
VCC = ±5 V
6.3
20
SR _{Slew rate‡}
VCC = ±15 V, 20-V step,
Gain = 5
400
VCC = ±5 V,
5-V step,
Gain = –1
325
Settling time to 0.1%
ts
Settling time to 0.01%
VCC = ±15 V, 5-V step
Gain = –1
120
VCC = ±5 V,
2-V step
120
VCC = ±15 V, 5-V step
Gain = –1
250
VCC = ±5 V,
2-V step
280
† _{Full range = 0°C to 70°C for C suffix and – 40°C to 85°C for I suffix}
‡ _{Slew rate is measured from an output level range of 25% to 75%.}
§ _{Full power bandwidth = slew rate / 2 π VO(Peak).}
UNIT
MHz
MHz
MHz
MHz
V/µs
ns
ns
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
3