SN74AUP1G17 Datasheet, PDF (3/16 Pages) Texas Instruments – LOW - POWER SINGLE SCHMITT-TRIGGLER BUFFER

SN74AUP1G17
LOWĆPOWER SINGLE SCHMITTĆTRIGGER BUFFER
SCES579C – JUNE 2004 – REVISED NOVEMBER 2005
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)^†
Supply voltage range, V_CC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Input voltage range, V_I (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Voltage range applied to any output in the high-impedance or power-off state, V_O
(see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
−0.5 V to 4.6 V
−0.5 V to 4.6 V
−0.5 V to 4.6 V
Output voltage range in the high or low state, V_O (see Note 1) . . . . . . . . . . . . . . . . . . . −0.5 V to V_CC + 0.5 V
Input clamp current, I_IK (V_I < 0) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −50 mA
Output clamp current, I_OK (V_O < 0) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −50 mA
Continuous output current, I_O . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±20 mA
Continuous current through V_CC or GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±50 mA
Package thermal impedance, θ_JA (see Note 2): DBV package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 206°C/W
DCK package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 252°C/W
DRL package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 142°C/W
YEP/YZP package . . . . . . . . . . . . . . . . . . . . . . . . . . . 132°C/W
Storage temperature range, T_stg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −65°C to 150°C
† _{Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and}
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. The input and output negative-voltage ratings may be exceeded if the input and output current ratings are observed.
2. The package thermal impedance is calculated in accordance with JESD 51-7.
recommended operating conditions (see Note 3)
MIN MAX UNIT
VCC Supply voltage
0.8 3.6 V
VI
Input voltage
0 3.6 V
VO
Output voltage
0 VCC V
VCC = 0.8 V
−20 µA
VCC = 1.1 V
−1.1
IOH‡ High-level output current
VCC = 1.4 V
VCC = 1.65
−1.7
−1.9 mA
VCC = 2.3 V
−3.1
VCC = 3 V
−4
VCC = 0.8 V
20 µA
VCC = 1.1 V
1.1
IOL‡ Low-level output current
VCC = 1.4 V
VCC = 1.65 V
1.7
1.9 mA
VCC = 2.3 V
3.1
VCC = 3 V
4
TA
Operating free-air temperature
−40
85 °C
‡ _{Defined by the signal-integrity requirements and design-goal priorities}
NOTE 3: All unused inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI application report,
Implications of Slow or Floating CMOS Inputs, literature number SCBA004.
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
3