MSP430G2X11_11 Datasheet, PDF (28/47 Pages) Texas Instruments – MIXED SIGNAL MICROCONTROLLER

MSP430G2x11
MSP430G2x01
SLAS695D – FEBRUARY 2010 – REVISED FEBRUARY 2011
www.ti.com
JTAG and Spy-Bi-Wire Interface – Electrical Characteristics
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)
f_SBW
t_SBW,Low
t_SBW,En
PARAMETER
Spy-Bi-Wire input frequency
Spy-Bi-Wire low clock pulse length
Spy-Bi-Wire enable time
(TEST high to acceptance of first clock edge⁽¹⁾)
TEST CONDITIONS
V_CC
2.2 V/3 V
2.2 V/3 V
2.2 V/3 V
MIN
0
0.025
TYP MAX
20
15
1
UNIT
MHz
µs
µs
t_SBW,Ret
f_TCK
Spy-Bi-Wire return to normal operation time
TCK input frequency⁽²⁾
2.2 V/3 V
15
2.2 V
0
3V
0
100 µs
5 MHz
10 MHz
R_Internal Internal pulldown resistance on TEST
2.2 V/3 V
25
60
90 kΩ
(1) Tools accessing the Spy-Bi-Wire interface need to wait for the maximum t_SBW,En time after pulling the TEST/SBWCLK pin high before
applying the first SBWCLK clock edge.
(2) f_TCK may be restricted to meet the timing requirements of the module selected.
JTAG Fuse⁽¹⁾ – Electrical Characteristics
over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)
PARAMETER
TEST CONDITIONS
MIN
V_CC(FB)
Supply voltage during fuse-blow condition
T_A = 25°C
2.5
V_FB
Voltage level on TEST for fuse blow
6
I_FB
Supply current into TEST during fuse blow
t_FB
Time to blow fuse
MAX
7
100
1
UNIT
V
V
mA
ms
(1) Once the fuse is blown, no further access to the JTAG/Test, Spy-Bi-Wire, and emulation feature is possible, and JTAG is switched to
bypass mode.
28
Submit Documentation Feedback
© 2010–2011, Texas Instruments Incorporated