OPA140_15 Datasheet, PDF (23/44 Pages) Texas Instruments – High-Precision, Low-Noise, Rail-to-Rail Output,11-MHz JFET Op Amp

www.ti.com
OPA140, OPA2140, OPA4140
SBOS498B – JULY 2010 – REVISED NOVEMBER 2015
Feature Description (continued)
Table 2 lists the EMIRR IN+ values for the OPA2140 at particular frequencies commonly encountered in real-
world applications. Applications listed in Table 2 may be centered on or operated near the particular frequency
shown. This information may be of special interest to designers working with these types of applications, or
working in other fields likely to encounter RF interference from broad sources, such as the industrial, scientific,
and medical (ISM) radio band.
FREQUENCY
400 MHz
900 MHz
1.8 GHz
2.4 GHz
3.6 GHz
5 GHz
Table 2. OPA2140 EMIRR IN+ for Frequencies of Interest
APPLICATION OR ALLOCATION
Mobile radio, mobile satellite, space operation, weather, radar, ultra-high frequency (UHF)
applications
Global system for mobile communications (GSM) applications, radio communication, navigation,
GPS (to 1.6 GHz), GSM, aeronautical mobile, UHF applications
GSM applications, mobile personal communications, broadband, satellite, L-band (1 GHz to 2 GHz)
802.11b, 802.11g, 802.11n, Bluetooth^®, mobile personal communications, industrial, scientific and
medical (ISM) radio band, amateur radio and satellite, S-band (2 GHz to 4 GHz)
Radiolocation, aero communication and navigation, satellite, mobile, S-band
802.11a, 802.11n, aero communication and navigation, mobile communication, space and satellite
operation, C-band (4 GHz to 8 GHz)
EMIRR IN+
53.1 dB
72.2 dB
80.7 dB
86.8 dB
91.7 dB
96.6 dB
7.3.10 EMIRR +IN Test Configuration
Figure 39 shows the circuit configuration for testing the EMIRR IN+. An RF source is connected to the op amp
noninverting input terminal using a transmission line. The op amp is configured in a unity gain buffer topology
with the output connected to a low-pass filter (LPF) and a digital multimeter (DMM). A large impedance mismatch
at the op amp input causes a voltage reflection; however, this effect is characterized and accounted for when
determining the EMIRR IN+. The resulting DC offset voltage is sampled and measured by the multimeter. The
LPF isolates the multimeter from residual RF signals that may interfere with multimeter accuracy.
Ambient temperature: 25Û&
RF source
DC Bias: 0 V
Modulation: None (CW)
Frequency Sweep: 201 pt. Log
+VS
±
50
+
-VS
Not shown: 0.1 µF and 10 µF
supply decoupling
Low-Pass Filter
Sample /
Averaging
Digital Multimeter
Figure 39. EMIRR +IN Test Configuration
7.4 Device Functional Modes
The OPAx140 has a single functional mode and is operational when the power-supply voltage is greater than
4.5 V (±2.25 V). The maximum power supply voltage for the OPAx140 is 36 V (±18 V).
Copyright © 2010–2015, Texas Instruments Incorporated
Submit Documentation Feedback
23
Product Folder Links: OPA140 OPA2140 OPA4140