BQ24195 Datasheet, PDF (23/41 Pages) Texas Instruments – I2C Controlled 2.5A / 4.5A Single Cell USB/Adapter Charger With 5.1V at 1A / 5.1V at 2.1A Synchronous Boost Operation

www.ti.com
bq24195
bq24195L
SLUSB97 – OCTOBER 2012
Table 3. Charging Parameter Default Setting
DEFAULT MODE
Charging Voltage
Charging Current
Pre-charge Current
Termination Current
Temperature Profile
Safety Timer
bq24195L, bq24195
4.208 V
2.036 A
256 mA
256 mA
Hot/Cold
8 hours⁽¹⁾
(1) See section Charging Safety Timer for more information.
A new charge cycle starts when the following conditions are valid:
• Converter starts
• Battery charging is enabled by I²C register bit (REG01[5:4]) = 01 and CE is low
• No thermistor fault on TS1 and TS2
• No safety timer fault
• BATFET is not forced to turn off (REG07[5])
The charger device automatically terminates the charging cycle when the charging current is below termination
threshold and charge voltage is above recharge threshold. When a full battery voltage is discharged below
recharge threshold (REG04[0]), the bq24195L, bq24195 automatically starts another charging cycle.
The STAT output indicates the charging status of charging (LOW), charging complete or charge disable (HIGH)
or charging fault (Blinking). The status register REG08[5:4] indicates the different charging phases: 00-charging
disable, 01-precharge, 10-fast charge (constant current) and constant voltage mode, 11-charging done. Once a
charging cycle is complete, an INT is asserted to notify the host.
The host can always control the charging operation and optimize the charging parameters by writing to the
registers through I²C.
Battery Charging Profile
The device charges the battery in three phases: preconditioning, constant current and constant voltage. At the
beginning of a charging cycle, the device checks the battery voltage and applies current.
VBAT
<2V
2V-3V
>3V
Table 4. Charging Current Setting
CHARGING CURRENT
100mA
REG03[7:4]
REG02[7:2]
REG DEFAULT SETTING
–
256mA
2048mA
REG08[5:4]
01
01
10
Copyright © 2012, Texas Instruments Incorporated
Product Folder Links: bq24195 bq24195L
Submit Documentation Feedback
23