BQ24072 Datasheet, PDF (21/38 Pages) Texas Instruments – 1.2A USB-FRIENDLY Li-Ion BATTERY CHARGER AND POWER-PATH MANAGEMENT IC

bq24072, bq24073
bq24074, bq24075
www.ti.com...................................................................................................................................... SLUS810A – SEPTEMBER 2008 – REVISED DECEMBER 2008
1200 mA
900 mAA
400 mA
0 mA
900 mA
500 mA
0 mA
500 mA
0 mA
-300 mA
4.4 V
4.3 V
~3.6 V
DPPM Loop Active _{Supplement Mode}
Figure 38. bq24073 DPPM and Battery Supplement Modes (V_OREG=4.4V, V_BAT = 3.6V)
INPUT SOURCE NOT CONNECTED
When no source is connected to the IN input, OUT is powered strictly from the battery. During this mode the
current into OUT is not regulated, similar to Battery Supplement Mode, however the short circuit circuitry is
active. If the OUT voltage falls below the BAT voltage by 250mV for longer than t_DGL(SC2), OUT is turned off. The
short circuit recovery timer then starts counting. After t_REC(SC2), OUT turns on and attempts to restart. If the short
circuit remains, OUT is turned off and the counter restarts. This ON/OFF cycle continues until the overload
condition is removed.
BATTERY CHARGING
Set CE low to initiate battery charging. First, the device checks for a short-circuit on the BAT pin by sourcing
I_BAT(SC) to the battery and monitoring the voltage. When the BAT voltage exceeds V_BAT(SC), the battery charging
continues. The battery is charged in three phases: conditioning pre-charge, constant current fast charge (current
regulation) and a constant voltage tapering (voltage regulation). In all charge phases, an internal control loop
monitors the IC junction temperature and reduces the charge current if an internal temperature threshold is
exceeded.
Figure 39 illustrates a normal Li-Ion charge cycle using the bq2407x:
Copyright © 2008, Texas Instruments Incorporated
Submit Documentation Feedback
21
Product Folder Link(s): bq24072 bq24073 bq24074 bq24075