English
Language : 

BQ24610_2 Datasheet, PDF (20/33 Pages) Texas Instruments – Stand-Alone Synchronous Switch-Mode Li-Ion or Li-Polymer Battery Charger with System Power Selector and Low Iq
bq24610
bq24617
SLUS892 – DECEMBER 2009
www.ti.com
Temperature Qualification
The controller continuously monitors battery temperature by measuring the voltage between the TS pin and
GND. A negative temperature coefficient thermistor (NTC) and an external voltage divider typically develop this
voltage. The controller compares this voltage against its internal thresholds to determine if charging is allowed.
To initiate a charge cycle, the battery temperature must be within the V(LTF) to V(HTF) thresholds. If battery
temperature is outside of this range, the controller suspends charge and the safety timer and waits until the
battery temperature is within the V(LTF) to V(HTF) range. During the charge cycle the battery temperature must
be within the V(LTF) to V(TCO) thresholds. If battery temperature is outside of this range, the controller suspends
charge and waits until the battery temperature is within the V(LTF) to V(HTF) range. The controller suspends
charge by turning off the PWM charge FETs. Figure below summarizes the operation.
VREF
VREF
VLTF
VLTFH
CHARGE SUSPENDED
TEMPERATURE RANGE
TO INITIATE CHARGE
CHARGE SUSPENDED
VLTF
VLTFH
TEMPERATURE RANGE
DURING A CHARGE
CYCLE
VHTF
CHARGE SUSPENDED
VTCO
CHARGE SUSPENDED
GND
GND
Figure 17. TS pin, Thermistor Sense Thresholds
Assuming a 103AT NTC thermistor on the battery pack as shown in Figure 1, the value RT1 and RT2 can be
determined by using the following equations:
VVR EF
´ RTHCOLD
´ RTHHOT
´
æ1
ç
è VLTF
-
1ö
÷
VHTF ø
RT2 =
R THHOT
´
æ
ç
VVR EF
è VHTF
ö
- 1÷ - RTHCOLD
ø
´
æ
ç
VVREF
-
ö
1÷
è VLTF ø
(8)
RT1 =
VVREF
VLTF
-1
1
1
+
RT2 RTHCOLD
(9)
VREF
bq24610/7
TS
RT1
RT2
RTH
103AT
20
Submit Documentation Feedback
Figure 18. TS Resistor Network
Product Folder Link(s): bq24610 bq24617
Copyright © 2009, Texas Instruments Incorporated