BQ24040 Datasheet, PDF (17/31 Pages) Texas Instruments – 800mA Single-Input Single Cell Li-Ion Battery Charger With Auto Start

bq24040
bq24041
www.ti.com.................................................................................................................................... SLUS941A – SEPTEMBER 2009 – REVISED SEPTEMBER 2009
Apply Input
Power
Is power good?
V_BAT+V_DT < V_IN < V_OVP
No
& V_UVLO < V_IN
Turn on PG FET
PG pin LOW
Yes
Is chip enabled?
No
V_TS > V_EN
Yes
Set Input Current Limit to 100 mA
and Start Charge
Perform ISET & OUT short tests
Remember ISET2 State
Set charge current
based on ISET2 truth
table.
Return to
Charge
Figure 25. bq2404x Power-Up Flow Diagram
Overvoltage-Protection (OVP) – Continuously Monitored
If the input source applies an overvoltage, the pass FET, if previously on, turns off after a deglitch, t_BLK(OVP). The
timer ends and the CHG and PG pin goes to a high impedance state. Once the overvoltage returns to a normal
voltage, the PG pin goes low, timer continues, charge continues and the CHG pin goes low after a 25ms
deglitch. PG pin is optional on some packages
Copyright © 2009, Texas Instruments Incorporated
Product Folder Link(s): bq24040 bq24041
Submit Documentation Feedback
17