GC3021A Datasheet, PDF (16/38 Pages) Texas Instruments – 3.3V MIXER AND CARRIER REMOVAL CHIP

GC3021A 3.3V MIXER AND CARRIER REMOVAL CHIP
SLWS137A
EOUT
SO
C[0:15]
A[0:8]
WE, RE
CE
VCC
GND
PHASE ERROR OUT. Active high
The phase error RAM output is clocked out of the chip on this pin.
This signal is made available mostly for diagnostic purposes.
SYNC OUT. Active low
This signal is either one of the input syncs, the one shot sync OS,
or the internal counter’s terminal count strobe TC.
CONTROL DATA I/O BUS. Active high
This is the 16 bit control data I/O bus. Control register contents are
loaded into the chip or read from the chip through these pins. The
chip will only drive these pins when CE and RE are low and WE is
high.
CONTROL ADDRESS BUS. Active high
These pins are used to address the control registers, phase error
RAM and the snapram memory within the chip.
READ/WRITE CONTROL. Active low
These pin determines if the control bus cycle is a read or write
operation.
CHIP ENABLE. Active low
This control strobe enables the chip for read or write operations.
SUPPLY VOLTAGE. Fixed voltage
The power supply pins.
CHIP GROUND. Fixed voltage
The power supply ground pins.
Texas Instruments Incorporated
- 14 -
This document contains information which may be changed at any time without notice