THS4520 Datasheet, PDF (15/23 Pages) Texas Instruments – WIDEBAND, LOW NOISE, LOW DISTORTION FULLY DIFFERENTIAL AMPLIFIER WITH RAIL-TO-RAIL OUTPUTS

www.ti.com
S-Parameter, Slew Rate, Transient Response,
Settling Time, Output Voltage
The circuit shown in Figure 31 is used to measure
s-parameters, slew rate, transient response, settling
time, and output voltage swing.
Because S21 is measured single-ended at the load
with 50-Ω double termination, add 12 dB to see the
amplifier’s output as a differential signal.
From ^VIN
50 Ω
Source
RG
R IT
0.22 mF
49.9 W
RG
R IT
RF
V_S+
THS4520
CM
V_S−
RF
49.9 W
49.9 W
Open
0.22 mF
V_{OUT+ To 50 W}
Test
V_OUT− ^Equipment
Figure 31. S-Parameter, SR, Transient Response,
Settling Time, V_OUT Swing
THS4520
SLOS503A – SEPTEMBER 2006 – REVISED OCTOBER 2006
CM Input
The circuit shown in Figure 32 is used to measure
the frequency response of the CM input. Frequency
response is measured single-ended at V_OUT+ or
V_OUT– with the input injected at V_IN, R_CM = 0 Ω and
R_CMT = 49.9 Ω.
0.22 mF
49.9 W
0.22 mF
49.9 W
RG
RIT
RG
RIT
RF
VS+
49.9 W
THS4520 _{49.9 W}
CM
VS–
RF
RCM
RCMT
To
VOUT– _50-W
Test
VOUT+ _Equipment
VIN From
50-W
Source
Figure 32. CM Input Test Circuit
Submit Documentation Feedback
15