SM74101 Datasheet, PDF (14/23 Pages) Texas Instruments – SM74101 Tiny 7A MOSFET Gate Driver

SM74101
SNOSBA2B – JULY 2011 – REVISED MAY 2015
www.ti.com
9 Power Supply Recommendations
A Low ESR/ESL capacitor must be connected close to the IC and between the V_CC and V_EE pins to support high
peak currents being drawn from V_CC during turn-on of the MOSFET. Also, if either channel is not being used, the
respective input pin (IN or INB) should be connected to either V_EE or V_CC to avoid spurious output signals.
10 Layout
10.1 Layout Guidelines
Attention must be given to board layout when using the SM74101. Proper grounding is crucial. The driver needs
a very low impedance path for current return to ground avoiding inductive loops. Two paths for returning current
to ground are a) between SM74101 IN_REF pin and the ground of the circuit that controls the driver inputs and
b) between SM74101 V_EE pin and the source of the power MOSFET being driven. Both paths should be as short
as possible to reduce inductance and be as wide as possible to reduce resistance. These ground paths should
be distinctly separate to avoid coupling between the high current paths (VCC, VEE, and OUT) and the logic
signal paths (IN, INB, and IN_REF) of the SM74101. With rise and fall times in the range of 10 to 30 ns, care is
required to minimize the lengths of current carrying conductors to reduce their inductance and EMI from the high
di/dt transients generated when driving large capacitive loads.
10.2 Layout Example
Figure 16 shows an example layout for the SM74101 configured in the non-inverting mode of operation. In this
mode, the INB pin is not used and is connected to IN_REF. Two low ESR/ESL capacitors, C1 and C2, are used
for input decoupling purposes and are placed as close as possible to the IC.
The level shift circuit and the separate input/output ground pins provide the option of single supply or split supply
configurations. When driving the MOSFET gate from a single positive supply, the control ground should be
connected to the power ground in an area of the board where the least amount of noise will exist. Otherwise,
when using a split supply configuration, the control ground and power ground paths should be distinctly separate
to avoid noise coupling between the two paths.
14
Submit Documentation Feedback
Product Folder Links: SM74101
Copyright © 2011–2015, Texas Instruments Incorporated