OPA354 Datasheet, PDF (12/23 Pages) Texas Instruments – 250MHz, Rail-to-Rail I/O, CMOS OPERATIONAL AMPLIFIERS

OPA354
OPA2354
OPA4354
SBOS233D − MARCH 2002− REVISED FEBRUARY 2005
OUTPUT DRIVE
The OPA354’s output stage can supply a continuous
output current of ±100mA and still provide approximately
2.7V of output swing on a 5V supply, as shown in Figure 2.
For maximum reliability, it is not recommended to run a
continuous DC current in excess of ±100mA. Refer to the
typical characteristic curve Output Voltage Swing vs
Output Current. For supplying continuous output currents
greater than ±100mA, the OPA354 may be operated in
parallel, as shown in Figure 3.
The OPA354 will provide peak currents up to 200mA,
which corresponds to the typical short-circuit current.
Therefore, an on-chip thermal shutdown circuit is provided
to protect the OPA354 from dangerously high junction
temperatures. At 160°C, the protection circuit will shut
down the amplifier. Normal operation will resume when the
junction temperature cools to below 140°C.
R₁
10kΩ
R₃
V_IN ^10kΩ
+
−
1V In = 100mA
Out, as Shown
C₁
50pF
R₂
1kΩ
1µF
V+
OPA354
V−
R₄
1kΩ
+
V₁
− ^5V
R_SHUNT
1Ω
Laser Diode
www.ti.com
R₁
100kΩ
R₃
100kΩ
+
−
2V In = 200mA
Out, as Shown
R₂
10kΩ
C₁
200pF
+5V
1µF
R₅
1Ω
OPA2354
R₆
1Ω
OPA2354
R₄
10kΩ
R_SHUNT
1Ω
Laser Diode
Figure 3. Parallel Operation
VIDEO
The OPA354 output stage is capable of driving standard
back-terminated 75Ω video cables, as shown in Figure 4.
By back-terminating a transmission line, it does not exhibit
a capacitive load to its driver. A properly back-terminated
75Ω cable does not appear as capacitance; it presents
only a 150Ω resistive load to the OPA354 output.
Figure 2. Laser Diode Driver
Video
In
+2.5V
+5V
75Ω
OPA354
+2.5V
604Ω
604Ω
75Ω
Video
Output
Figure 4. Single-Supply Video Line Driver
12