OPA454 Datasheet, PDF (1/36 Pages) Texas Instruments – High-Voltage (100V), High-Current (50mA) OPERATIONAL AMPLIFIERS, G = 1 Stable

BurrĆBrown Products
from Texas Instruments
OPA454
SBOS391 – DECEMBER 2007
High-Voltage (100V), High-Current (50mA)
OPERATIONAL AMPLIFIERS, G = 1 Stable
FEATURES
1
•23 WIDE POWER-SUPPLY RANGE:
±5V (10V) to ±50V (100V)
• HIGH OUTPUT LOAD DRIVE: I_O > ±50mA
• WIDE OUTPUT VOLTAGE SWING: 1V to Rails
• INDEPENDENT OUTPUT DISABLE OR
SHUTDOWN
• WIDE TEMPERATURE RANGE: –40°C to +85°C
• PACKAGES: SO and HSOP PowerPAD™
APPLICATIONS
• TEST EQUIPMENT
• AVALANCHE PHOTODIODE:
High-V Current Sense
• PIEZOELECTRIC CELLS
• TRANSDUCER DRIVERS
• SERVO DRIVERS
• AUDIO AMPLIFIERS
• HIGH-VOLTAGE COMPLIANCE CURRENT
SOURCES
• GENERAL HIGH-VOLTAGE
REGULATORS/POWER
Status
Flag
V+
Enable/Disable (E/D)
-IN
OPA454
V_O
+IN
Enable/Disable Common
(E/D Com)
V-
DESCRIPTION
The OPA454 is a low-cost operational amplifier with
high voltage (100V) and relatively high current drive
(25mA). It is unity-gain stable and has a
gain-bandwidth product of 2.5MHz.
The OPA454 is internally protected against
over-temperature conditions and current overloads. It
is fully specified to perform over a wide power-supply
range of ±5V to ±50V or on a single supply of 10V to
100V. The status flag is an open-drain output that
allows it to be easily referenced to standard
low-voltage logic circuitry. This high-voltage op amp
provides excellent accuracy, wide output swing, and
is free from phase inversion problems that are often
found in similar amplifiers.
The output can be independently disabled using the
Enable/Disable Pin that has its own common return
pin to allow easy interface to low-voltage logic
circuitry. This disable is accomplished without
disturbing the input signal path, not only saving power
but also protecting the load.
Featured in a small exposed metal pad package, the
OPA454 is easy to heatsink over the extended
industrial temperature range, –40°C to +85°C.
Table 1. OPA454 RELATED PRODUCTS
PRODUCT
OPA445 ⁽¹⁾
OPA452
OPA547
OPA548
OPA549
OPA551
OPA567
OPA569
DESCRIPTION
80V, 15mA
80V, 50mA
60V, 750mA
60V, 3A
60V, 9A
60V, 200mA
5V, 2A
5V, 2.4A
(1) The OPA445 is pin-compatible with the OPA445, except in
applications using the offset trim, and NC pins other than
open.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PowerPAD is a trademark of Texas Instruments, Inc.
2
All other trademarks are the property of their respective owners.
3
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2007, Texas Instruments Incorporated