|
THC63LVD1027 Datasheet, PDF (3/22 Pages) THine Electronics, Inc. – 85MHz 10Bits Dual LVDS Repeater | |||
|
◁ |
THC63LVD1027_Rev.2.0_E
Pin Description
Pin Name
RA1+/â
RB1+/â
RC1+/â
RD1+/â
RE1+/â
RCLK1+/â
RA2+/â
RB2+/â
RC2+/â
RD2+/â
RE2+/â
Direction
Input
RCLK2+/â
TA1+/â
TB1+/â
TC1+/â
TD1+/â
TE1+/â
TCLK1+/â
TA2+/â
TB2+/â
TC2+/â
TD2+/â
TE2+/â
TCLK2+/-
Output
PD
RS
MODE1
MODE0
Input
VDD
GND
CAP
Power
Type
LVDS
LV-TTL
â
Description
LVDS data input for channel A of 1st Link
LVDS data input for channel B of 1st Link
LVDS data input for channel C of 1st Link
LVDS data input for channel D of 1st Link
LVDS data input for channel E of 1st Link
LVDS clock input for 1st Link
LVDS data input for channel A of 2nd Link
LVDS data input for channel B of 2nd Link
LVDS data input for channel C of 2nd Link
LVDS data input for channel D of 2nd Link
LVDS data input for channel E of 2nd Link
LVDS clock input for 2nd Link
In Distribution and Single-in/Dual-out mode, RCLK2+/- must be Hi-Z.
(see âMode selectionâ below in this page.)
LVDS data output for channel A of 1st Link
LVDS data output for channel B of 1st Link
LVDS data output for channel C of 1st Link
LVDS data output for channel D of 1st Link
LVDS data output for channel E of 1st Link
LVDS clock output for 1st Link
LVDS data output for channel A of 2nd Link
LVDS data output for channel B of 2nd Link
LVDS data output for channel C of 2nd Link
LVDS data output for channel D of 2nd Link
LVDS data output for channel E of 2nd Link
LVDS clock output for 2nd Link
Power Down
H: Normal operation
L: Power down state, all LVDS output signals turn to Hi-Z
LVDS output swing level selection
H: Normal swing
L: Reduced swing
Mode selection
MODE1 MODE0 RCLK2+/-
Description
L
L
clkin
Dual-in / Dual-out mode
L
L
Hi-Z
Distribution mode
H
L
Hi-Z
Single-in / Dual-out mode
L
H
clkin
Dual-in / Single-out mode
H
H
-
Reserved
In Distribution and Single-in/Dual-out mode, RCLK2+/- must be Hi-Z.
3.3v power supply pins
Ground pins (Exposed PAD is also Ground)
Decoupling capacitor pins
These pins should be connected to external decoupling capacitors (CCAP).
Recommended CCAP is 0.1uF
Copyright©2010 THine Electronics, Inc.
3/22
THine Electronics,Inc.
|
▷ |