DG213 Datasheet, PDF (3/7 Pages) TEMIC Semiconductors – Quad Complementary CMOS Analog Switch

DG213
Specifications
Parameter
Power Supply
Positive Supply Current
Negative Supply Current
Logic Supply Current
Power Supply Range for
Continuous Operation
Symbol
Test Conditions
Unless Otherwise Specified
V+ = 15 V, V– = –15 V
V_L = 5 V, V_IN = 2.4 V, 0.8 V^e
D Suffix
–40 to 85_C
Temp^a Min^c Typ^b Max^c Unit
I+
Room
Full
V_IN = 0 or 5 V
I–
Room –1
Full
–5
I_L
Room
Full
1
5
mA
1
5
V_OP
Full
"3
"22 V
Specifications for Unipolar Supply
Parameter
Analog Switch
Analog Signal Range^d
Drain-Source On-Resistance
Symbol
V_ANALOG
r_DS(on)
Dynamic Characteristics
Turn-On Time
t_ON
Turn-Off Time
t_OFF
Break-Before-Make Time Delay
t_D
Charge Injection
Q
Power Supply
Positive Supply Current
I+
Negative Supply Current
I–
Logic Supply Current
I_L
Power Supply Range for
Continuous Operation
V_OP
Test Conditions
Unless Otherwise Specified
V+ = 12 V, V– = 0 V
V_L = 5 V, V_IN = 2.4 V, 0.8 V^e
D Suffix
–40 to 85_C
Temp^a Min^c Typ^b Max^c Unit
V_D = 3 V, 8 V, I_S = 1 mA
Full
V–
V+
V
Room
Full
90
110
140
W
V_S = 8 V
See Figure 2
DG213 Only, See Figure 3
C_L = 1 nF, V_gen= 6 V, R_gen = 0 W
Room
Room
Room 50
Room
125
200
45
100
ns
80
4
pC
V_IN = 0 or 5 V
Room
Full
Room –1
Full
–5
Room
Full
Full
)3
1
5
mA
1
5
)40 V
Notes:
a. Room = 25_C, Full = as determined by the operating temperature suffix.
b. Typical values are for DESIGN AID ONLY, not guaranteed nor subject to production testing.
c. The algebraic convention whereby the most negative value is a minimum and the most positive a maximum, is used in this data sheet.
d. Guaranteed by design, not subject to production test.
e. V_IN = input voltage to perform proper function.
Siliconix
3
S-56461—Rev. C, 29-Dec-97