English
Language : 

TC25C25 Datasheet, PDF (5/7 Pages) TelCom Semiconductor, Inc – BICMOS PWM CONTROLLERS
BICMOS PWM CONTROLLERS
1
TC25C25
TC35C25
OUTPUT SECTION
The output stage of the TC35C25 is comprised of two
pairs of complimentary CMOS drivers operating in a push-
pull mode. Each output is capable of sinking or sourcing
nearly 500mA of peak current. They are also capable of
absorbing just as much "kick-back" current without latching.
SOFT START
A soft restart recovery rate may be selected by placing
a capacitor from SOFT START (pin 8) to ground. The
calculation for the recovery timing is approximately 60 msec/
µF.
SOFT START will mediate the start-up from under
voltage recovery, power-on, or SHUTDOWN.
SHUTDOWN
There is a minimum delay, non-latching shutdown fea-
ture on the TC35C25 PWM controller. Both outputs may be
turned off by applying a positive voltage to SHUTDOWN (pin
10). Typical shutdown threshold is 2.4V. Returning the pin
back to ground will reinitialize the soft start cycle.
OSCILLATOR SECTION
A tri-state feature has been added to accommodate
systems which require multiple controllers to be run in a
"master/slave" configuration. The timing resistor pin (RT, pin
6) may be tied to VREF to place the sync pin (SYNC, pin 3)
in a high impedance state. This will allow the chip to be
clocked from an external source.
The sync output (OSC OUT, pin 4) of the TC35C25 can
drive several sync inputs configured in this manner.
OSCILLATOR SYNCHRONIZATION
Synchronization of two TC35C25's can be done by
making one PWM Controller as the master oscillator to
synchronize the slave as follows:
6 RT
RT
TCx5C25
MASTER
5 CT GND
CT
12
OSC OUT
4
6 RT
16
VREF
3
SYNC
5 CT
TCx5C25
GND
12
SLAVE
OSCILLATOR SYNCHRONIZATION WITH
SEPARATE RC TIMER
2
Synchronization can also be done by having a separate
RC timing circuit on the slave oscillator that is slightly lower
frequency than the master oscillator. The sync input will not
be in a high impedance state so the number of slave
oscillators is limited. This method of synchronization is
useful when slave oscillator is located in a different location.
3 When a separate RC timer is used in the slave controller,
ground loop noise pickup in the oscillator is minimized.
6 RT
RT
MASTER
TCx5C25
5 CT GND
OSC OUT
CT
12
4
6
RT
VREF
3
SYNC
RT
TCx5C25
5 CT GND
CT
12
SLAVE
SLAVE TC > MASTER TC
4
5
6
7
8
TELCOM SEMICONDUCTOR, INC.
4-115