408-32120 Datasheet, PDF (7/7 Pages) TE Connectivity Ltd – EYE Check Terminal Alignment Aid

408-32120
5. USING THE CAMERA ON CQM II
5.1. Setup
To use the camera on the CQM II, the CQM II must have software version 2.03.02 or greater. It is
recommended using a USB mouse with the CQM II for clicking the alignment line positions because the touch
screen response and accuracy is less exact.
1. Plug the camera into one of the USB ports on the CQM II host module.
2. In the software, select the Control Panel, then choose the EYE Check terminal alignment aid icon.
NOTE
The operation of the software is similar to the operating system software previously described.
To exit the camera application, touch the back arrow.
5.2. Image Capture
Captured images are saved to a USB flash drive if connected; otherwise, to the internal memory.
The CQM II has two USB ports: one occupied by the camera and the other by the mouse; therefore, the CQM II
software will automatically copy the images stored internally onto a USB flash drive that is later connected.
Image files are large; allow time for the images to copy.
After the images are captured, the camera or mouse can be disconnected to free a port for the USB flash drive.
If the camera is disconnected, it will be necessary to exit the camera screen using the Return (green) button
and then re-enter the camera screen before the camera will work again.
To avoid data loss, eject the flash drive as follows:
Touch the (green) Return button to exit the camera screen.
Wait until the indicator on the USB flash drive stops flashing, then touch the Eject button. The Eject
button is not displayed on the camera screen, but it is displayed on all CQM II screens.
If the files are still being copied, a small Wait dialog with the message, “Ejecting flash.” will be
displayed until the files are copied. See Figure 10. Wait until the message, “It is safe to remove the
flash drive.” is displayed before removing the flash drive.
Figure 10
6. REVISION SUMMARY
Revisions to this instruction sheet include:
 Modified Step 2 and NOTE of Paragraph 3.2
 Added photo to Figure 2
Rev C
7 of 7