408-32120 Datasheet, PDF (4/7 Pages) TE Connectivity Ltd – EYE Check Terminal Alignment Aid

Adjust Focus
Select Camera
408-32120
Focus Adjusting
Barrel
Figure 4
3. Position the terminal so that there is a clear view of the anvil.
4. Position the alignment lines by selecting the line that represents each of the first 4 alignment buttons
as follows:
NOTE
Alternatively, if it is easier to view, the red alignment lines can be positioned using the upper tooling. Doing this would make it
necessary to manually position the terminator in order to lower the upper tooling into view.
a. Click the Select Left Side of Anvil button, then click the left edge of the anvil. See Figure 5.
b. Click the Select Right Side of Anvil button, then click on the right edge of the anvil. See Figure 5.
Red Alignment Line on Left Edge of Anvil
Red Alignment Line on Right Edge of Anvil
Select Left Side of Anvil
Button
Figure 5
Select Right Side of Anvil
Button
c. Cycle the terminator.
d. Click the Select Left Side of Terminal button, and click the left side of the terminal wire barrel or
other prominent feature of the terminal. See Figure 6.
e. Click the Select Right Side of Terminal button, then click the right side of the terminal wire barrel or
other prominent feature of the terminal. See Figure 6.
Rev C
4 of 7