408-8703 Datasheet, PDF (6/6 Pages) TE Connectivity Ltd – Crimping Die Assemblies

Detail A
Inspection of Die Closure with Plug Gage
Detail B
408- 8703
“GO” Gage Must Pass Completely
Through the Die Closure
Dies Bottomed But Not Under Pressure
Figure 8
“NO- GO” Gage May Enter Partially,
But Must Not Pass Completely
Through the Die Closure
2. Mate the dies until it is evident that they have
bottomed. Hold the dies in this position.
3. Hold gage in straight alignment with die closure
and carefully try to insert, without forcing, the GO
member. See Figure 8, Detail B. The GO member
must pass completely through the die closure.
4. Try to insert the NO--GO member. The NO--GO
member may enter partially, but must not pass
completely through die closure.
5. If die closure meets GO/NO--GO gage
conditions, dies may be considered dimensionally
correct. If die closure does not conform with
GO/NO--GO gage conditions, the dies must be
replaced.
7. REPLACEMENT PARTS
Worn or damaged dies may not be repaired. It is
recommended that spare sets be stocked and
controlled to prevent lost time. See Figure 9. Order
replacement dies through your TE Representative, or
call 1--800--526--5142, or send a facsimile of your
purchase order to 1--717--986--7605, or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105--3608
For tool repair service, please contact a TE
Representative at 1--800--526--5136.
8. REVISION SUMMARY
S Updated document to corporate requirements
S Corrected table in Figure 1
Single Position Dies
2
1
ITEM DESCRIPTION
1 Moving Die
2 Stationary Die
1583092- 1
1490351--1
1490352--1
1583093- 1
1490351--2
1490352--2
SINGLE POSITION DIES
1583094- 1 1583095- 1 1583096- 1
1490351--3 1490351--4 1490351--5
1490352--3 1490352--4 1490352--5
Figure 9
1583097- 1
1490351--6
1490352--6
1583098- 1
1490351--7
1490352--7
6 of 6
Rev B