408-8703 Datasheet, PDF (2/6 Pages) TE Connectivity Ltd – Crimping Die Assemblies

408- 8703
Wire Strip Lengths
Length of Barrel “B” Plus 1.6 [.062] 1/16
(Except Terminals and Butt Splices)
DANGER
AVOID PERSONAL INJURY. When changing
dies, exercise caution and avoid accidentally
depressing foot switch or trigger controls of
power units.
B +1.6 [.062] 1/16
B
B +1.6 [.062] 1/16
3.1. Die Insertion
Refer to Figures 1 and 3 for a listing of tooling that
these dies will fit into. Ensure that the possibility of
B
B +1.6 [.062] 1/16 accidental activation of the hydraulic power unit has
been eliminated, and proceed as follows:
BB
1. Depress the upper release button located in the
C--head and slide the nest into place.
2. Release the button and rock the die
back--and--forth until the nest snaps in place.
B
BB
B
Figure 2
3. DIE INSERTION AND REMOVAL
CAUTION
!
Do not operate the tool without the dies.
Tools Using Crimping Dies for AMPOWER
Terminals and Splices (Refer to Figure 1)
3. Activate the power unit until the lower die
release button located in the ram is exposed.
4. Depress the release button and slide the
indenter into place.
5. Release the button and rock the indenter
back--and--forth until the die snaps in place.
6. Return the ram to the down position.
Hydraulic Hand
Tool 1490748- 1
Hydraulic Hand
Tool 1490749- 1
- CAUTION
-
electrical lines.
- WARNING
Hydraulic Head
1490745- 1
Hydraulic Head
1490746- 1
Hydraulic Head
1490747- 1
Figure 3
2 of 6
-
-
-
Rev B