408-8848 Datasheet, PDF (4/6 Pages) TE Connectivity Ltd – Reasons for reissue are provided in Section 8, REVISION SUMMARY.

408-8848
6.1. Daily Maintenance
It is recommended that each operator be made aware of, and responsible for, the following steps of daily
maintenance.
1. Remove dust, moisture, and contaminants with a clean, soft brush or a lint-free cloth. DO NOT use
objects that could damage the components.
2. When the seating tool and wall support are not in use, store them in a clean, dry area.
6.2. Periodic Inspection
Regular inspections should be performed by quality control personnel. A record of scheduled inspections
should remain with the seating tool or be supplied to personnel responsible for the seating tool kit. Inspection
frequency should be based on amount of use, working conditions, operator training and skill, and established
standards.
7. REPLACEMENT AND REPAIR
Customer-replaceable parts are listed in Figure 3.
A complete inventory should be stocked and controlled to prevent lost time when replacement of parts is
necessary. Parts other than those listed should be replaced by TE Connectivity to ensure quality and reliability.
Order replacement parts through your TE Representative, or call 1-800-522-6752, or send a facsimile of your
purchase order to 717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
8. REVISION SUMMARY
Revisions to this instruction sheet include:
 Updated document to corporate requirements
Added new seating tool kits to table in Figures 1, 2, and 3
Rev F
4 of 6