408-8848 Datasheet, PDF (3/6 Pages) TE Connectivity Ltd – Reasons for reissue are provided in Section 8, REVISION SUMMARY.

408-8848
3. Place the product on the pc board so that the contacts and alignment posts are aligned and started
into the matching holes in the pc board.
4. Center the seating tool (with the product) under the ram of the application tool. Slowly lower the ram
until it just meets the seating tool. Verify alignment of pc board support, pc board, product, and seating
tool.
CAUTION
Damage to the pc board, seating tool, or product may occur if the seating tool is not properly seated on the product before
cycling the application tool.
5. Cycle the application tool to seat the product on the pc board. Then retract the ram, and carefully
remove the seating tool by pulling it straight from the product.
NOTE: Not to scale
Ram of Applicator
Tool (Fully Down)
Tool Seating Height
(See Table)
(With Product Seated)
Seating Tool
(1490197-2 Shown)
Cage Assembly
Application Tool
Shut Height
(Ram Fully Down)
(See Section 4, Step 1)
0.10 [.004] (Max)
Gap Allowed
Wall Support (Installed in
Ports of Cage Assembly)
Compliant Pin Contacts (and Any Protruding
Components) Inserted into Holes in PC
Board and PC Board Support Fixture
PC Board
PC Board Support Fixture
SFP PRODUCT
CONFIGURATION
1 x 2, 1 x 4, 1 x 6
2 x 1, 2 x 4, 2 x 6
PROFILE
---
Standard
Low
Figure 2
SEATING HEIGHT (mm [in.])
TOOL
PRODUCT
38.61 [1.52]
9.7 [.382]
40.64 [1.60]
25.5 [1.004]
37.59 [1.48]
22.55 [.888]
6. Check the product for proper seating according to the following:
a. the widest section of each compliant pin is inside its intended pc board hole
b. each alignment post is in its intended pc board hole
c. the product is seated on the pc board with a seating height-measured from the top of the product
(not including the panel ground springs) to the top of the pc board-given in Figure 2
d. if present, the gap between the standoffs and the pc board is no more than 0.10 mm [.004 in.]
NOTE
For detailed application requirements of the product, refer to the relative application specification listed in Figure 1.
6. MAINTENANCE AND INSPECTION
The seating tool is assembled and inspected before shipment. It is recommended that the seating tool be
inspected immediately upon arrival at your facility to ensure that it has not been damaged during shipment, and
that it conforms to the dimensions provided in Figure 3.
Rev F
3 of 6