408-4153 Datasheet, PDF (4/4 Pages) TE Connectivity Ltd – Tooling Assemblies

408- 4153
before returning them to service (see Section 6,
REPLACEMENT AND REPAIR).
For additional information concerning the use of a
plug gage, refer to instruction sheet 408--7424.
GO
Suggested Plug Gage Design
NO- GO
Dim.
Dim.
6. REPLACEMENT AND REPAIR
Replacement parts are listed in Figure 2. Parts other
than those listed in Figure 2 should be replaced by TE
to ensure quality and reliability of the tool. Order
replacement parts through your TE Representative, or
call 1--800--526--5142, or send a facsimile of your
purchase order to 1--717--986--7605, or write to:
Crimping
Chamber
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105--3608
GO Element
GO element must pass
completely through the
die closure.
NO- GO Element
NO- GO element may enter
partially, but must not pass
completely through the
die closure.
DIE ASSEMBLY
PART NUMBER
224027--1
224027--2
ELEMENT DIAMETER
GO
NO- GO
2.464 [.0970]
2.616 [.1030]
2.337 [.0920]
2.489 [.0980]
Figure 3
For tool repair service, please contact a TE
Representative at 1--800--526--5136.
7. REVISION SUMMARY
Since the previous release of this sheet, the following
changes were made:
S Updated document to corporate requirements.
4 of 4
Rev B