408-4153 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Tooling Assemblies

Crimping Die Assemblies 224027- 1 and - 2
for Use with 626 Pneumatic
Tooling Assemblies
Instruction Sheet
408- 4153
21 Mar 11 Rev B
Die Holding
Screw
Wire and Receptacle
Size Identification
Marked in This
Approximate Area
Moving Die
(Indenter)
~
Wire Barrel
Stationary
Die (Anvil)
Terminal Loaded
This Side
NOTE: Not to Scale.
NOTE: Use Wire With Stranded Conductors Only.
Wire Strip
Length: 7.94 [.313]
WIRE
SIZE
(AWG)
10
12
CRIMPING
DIE ASSEMBLY
224027--1
224027--2
PART NUMBERS
STRIP
4--520447--2
4--520447--2
TERMINALS
LOOSE- PIECE
4--520448--2
4--520448--2
TERMINAL
HOUSING
COLOR
Yellow
Yellow
Figure 1
1. INTRODUCTION
This instruction sheet covers the use of Crimping Die
Assemblies 224027--1 and --2 which are designed for
use in 626 Pneumatic Tooling Assemblies to crimp
the Ultra--Fast Fully Insulated FASTON* receptacle
terminals listed in Figure 1.
NOTE
i
All dimensions on this instruction sheet are in
metric units [with U.S. customary units in
brackets].
NOTE
i
This die assembly requires Adapter Holder
189928- 1 and Straight Action Crimper 217200- 1
to operate in the 626 Pneumatic Tooling System.
This sheet also covers terminal and wire
specifications, maintenance and inspection
procedures, and general performance of the crimping
die assemblies. Read customer manual 409--5862,
packaged with the pneumatic tool, for information
concerning die assembly installation and general
performance of the pneumatic tool.
Reasons for reissue are provided in Section 7,
REVISION SUMMARY.
2. DESCRIPTION
Each die assembly consists of a stationary die (anvil)
and a moving die indenter. The stationary die features
a die holding screw, applicable wire size markings,
and the part number of the die assembly. The moving
die features a die holding screw, the part number of
the die assembly, and “Ultra--Fast” marking for the
type of terminal it is designed to crimp.
A terminal locator/stop (locator) is an integral part of
each die assembly. The locator is designed to serve
as a terminal stop, positioning the terminal properly
between the dies for crimping.
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1--800--722--1111
All Rights Reserved
PRODUCT INFORMATION 1--800--522--6752
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.
*Trademark. Other logos, product and/or Company names may be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
1 of 4
LOC B