408-32121 Datasheet, PDF (4/4 Pages) TE Connectivity Ltd – Installation of Air Feed Module

408-32121
turn the screw until it stops against the
bushing. Now tighten an additional 1/4 to 1/2
turn to secure the bushing.
21. Re-install the rear retaining ring in the
housing ring groove.
22. Pull the shaft assembly to the rear against
the retaining ring. Repeat Step 20.
23. Re-install the backstroke adjustment knob
and mounting screw. See Figure 13. Note:
The adjustment knob is used to rotate the
entire shaft assembly to adjust the feed arm
assembly. The mounting bolt must be tight
enough to prevent the Adjustment Knob from
turning relative to the Piston Shaft. A
screwdriver slot is provided in the front of the
shaft to hold the shaft stationary while
tightening the mounting screw. See
Figure 14.
3. REVISION SUMMARY
●Added lubricant number in Paragraph 2.13
NOTE
Figure 13
Figure 14
24. Re-install the remaining components in the
reverse order of disassembly.
25. Re-attach the air feed to the applicator and
follow the applicator instruction sheet to
properly set-up the feed positions.
Rev C
4 of 4