408-32121 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Installation of Air Feed Module

Installation of Air Feed Module
Re-Build Kit 2217901-1, -2, and -3
Instruction Sheet
408-32121
30 DEC 14 Rev C
1. INTRODUCTION
These instructions describe the procedure for
rebuilding Ocean Air Feed Module 2063440-1, -2,
and -3 using Rebuild Kit 2217901-1, -2, and -3.
NOTE
The following procedure is performed with the
air feed module removed from the applicator.
For instructions on proper removal or
installation of the air feed module from the
applicator or for applicator set-up, please see
the appropriate instruction sheet. Refer to
Instruction Sheet 408-10389 for Ocean Side
Feed applicators. Refer to Instruction Sheet
408-10390 for Ocean End Feed applicators.
2. Remove two set screws holding the front
and rear shaft support bushings. See
Figure 3 and Figure 4.
NOTE
Refer to assembly drawing 2063440 for
specific part numbers.
2. REBUILD PROCEDURE
Rebuild as follows:
1. Remove the end cap and cover plate from
the air feed. Refer to Figure 1 and Figure 2.
Figure 3
Figure 1
Figure 4
3. Remove the button head screw from the
front end of the shaft assembly. See
Figure 5.
Figure 2
Figure 5
© 2014 TE Connectivity Ltd. family of companies
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 4