|
408-32121 Datasheet, PDF (2/4 Pages) TE Connectivity Ltd – Installation of Air Feed Module | |||
|
◁ |
4. Remove the feed arm assembly from the
piston shaft by rotating the backstroke
adjustment knob until the feed arm assembly
comes completely off the shaft. See
Figure 6.
408-32121
Figure 6
5. Remove the backstroke adjustment knob by
removing the mounting screw. See Figure 7
Figure 8
8. Remove the piston shaft assembly from the
housing by firmly holding the adjust wheel
and pulling straight out. Refer to Figure 9.
Figure 7
6. Lightly re-install the button head screw
(removed in Step 3) into the shaft end.
7. Using a retaining ring tool (recommended
tool â Craftsman Pliers 47411) remove the
rear ring from its groove. A new retaining
ring is provided in the rebuild kit. Refer to
Figure 8.
Craftsman is a trademark.
Rev C
Figure 9
9. Remove the shaft support bushings from the
shaft.
10. Remove the outer and inner O-rings from the
end caps using a pick tool or similar. See
Figure 10.
2 of 4
|
▷ |