408-9010 Datasheet, PDF (3/4 Pages) TE Connectivity Ltd – Shielding Hardware Kits with AMPLIMITE

5. For HDE--20 connectors, obtain 3MV Scotch
Tape 44 (or equivalent), 9.53 mm [.375 in.] wide.
Wrap the tape around the terminated contacts two
complete times. See Figure 4.
HDE- 20
Connector
HDP- 20, HDP- 22
Connector
408- 9010
9.53 mm
[.375 in.]
HDE- 20
Connector (Ref)
Wrapped
Tape
Terminated
Strip Length
Wire
Bundle
Braid
Tape (Two Wraps)
Figure 4
Cable
Jacket
Ferrule
4. SHIELD ASSEMBLY PROCEDURE
1. Measure the terminated length of the assembly
as shown in Figure 5.
CAUTION
!
The length must be as indicated in Figure 5 and
must conform to the configuration as shown in
the illustration; otherwise, wires may be pinched
between the shields when they are closed. The
proper length and configuration may be achieved
by twisting (and thereby shortening) the wire
bundle after termination; however, make certain
that no undue stress is placed on the terminated
contacts during the procedure. The MAXIMUM
amount that the bundle may be twisted to
achieve the desired length is 90_.
2. Insert the hinge tabs of the inner shield into the
corresponding slots of the connector and rotate the
shield 90_ toward the cable. See Figure 6.
3. Insert the hinge tabs of the outer shield into the
corresponding slots of the connector. See Figure 6.
4. Make sure that the inner shield is in its final
position and close the outer shield until it latches
onto the inner shield with the two latching tabs fully
engaged. See Figure 7.
CONNECTOR
TYPE
HDE--20
HDP--20
HDP--22
CONTACT
POSITION
9, 15, 25
37
9, 15, 25
37
50
15, 26, 44
62
78
Figure 5
TERMINATED
STRIP LENGTH
+1.27 [+.050] (mm [in.])
33.02 [1.300]
38.10 [1.500]
33.02 [1.300]
40.64 [1.600]
38.10 [1.500]
33.02 [1.300]
40.64 [1.600]
38.10 [1.500]
CAUTION
!
Take care not to pinch any individual wires
between the shields.
5. Slide the braid over the braid crimp area of the
mated shields. See Figure 7.
6. Slide ferrule forward until it is over the braid and
butted against the shield assembly.
V Trademark of Minnesota Mining & Manufacturing Co.
Rev C
3 of 4