408-32163 Datasheet, PDF (3/4 Pages) TE Connectivity Ltd – Enhanced Small Form-Factor

408-32163
5.1. Daily Maintenance
It is recommended that each operator be made aware of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and contaminants with a clean, soft brush or a lint-free cloth. DO NOT use
objects that could damage the extraction tool kits components.
2. When the extraction tool kit is not in use, store it in a clean, dry area.
5.2. Periodic Inspection
Regular inspections should be performed by quality control personnel. A record of scheduled inspections
should remain with the extraction tool kit or be supplied to personnel responsible for the extraction tool kit.
Inspection frequency should be based on amount of use, working conditions, operator training and skill, and
established standards.
6. REPLACEMENT AND REPAIR
Customer-replaceable parts are listed in Figure 3. A complete inventory should be stocked and controlled to
prevent lost time when replacement of parts is necessary. Parts other than those listed should be replaced by
TE Connectivity to ensure quality and reliability. Order replacement parts through your TE Representative, or
call 1-800-526-5142, or send a facsimile of your purchase order to 717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
7. REVISION SUMMARY
 Initial release of document
1 X 4 Extraction Tool Kit Shown
A
2
40.4 [1.591]
1
40.00 [1.575]
43.22 [1.702]
3
50.8 [2.00]
Rev A
50.8 [2.00]
5.72 [.225]
142.85 [5.624]
40.4 [1.591]
101.6 [4.00]
5
Figure 3 (cont’d)
25.4 [1.00]
4 _{41.80 [1.646]}
3 of 4