408-2822 Datasheet, PDF (3/7 Pages) TE Connectivity Ltd – Crimping Die Assemblies

ACCEPT
PIDG Type Terminals
and Splices Shown
4
3
2
PIDG and PLASTI- GRIP
Terminals and FASTON
Receptacles
2
Wire Range
Stamped Here
4
67
Wire Stop
5
2 ^{Wire Range}
Stamped Here
3
PIDG Butt Splices
Wire Stop
1
7
5
3
408- 2822
REJECT
4
2
2
Wire Range
Stamped Here
6 74
Wire Stop
2 Wire Range
Stamped Here
43
5
1
1 Correct product insulation color and die set combination.
2 Wire size is within wire range stamped under terminal
tongue or on center of splice.
3 _{Crimp centered on wire barrel.}
4 _{End of conductor is flush with, or extends slightly beyond}
end of terminal wire barrel.
5 End of conductor against wire stop of splice, or at least
flush with, or extended slightly beyond wire barrel.
6 Wire insulation does not enter wire barrel.
7 No nicked or missing conductor strands.
1 Wrong product insulation color and die set combination.
2 Wire size is not within wire range stamped on terminal
tongue or splice.
3 Crimp not centered on wire barrel. See machine manual
for terminal positioning and crimp location adjustments.
4 End of conductor is not flush with or extending beyond
end of wire barrel. (Check for correct strip length.)
5 Excessive flash or extruded insulation, (wrong die set,
terminal, or splice combination, or damaged dies.)
6 Wire insulation entered wire barrel.
7 Nicked or missing conductor strands.
Figure 3
Rev B
3 of 7