408-10154 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – These connectors consist of a plug and a receptacle

408-10154
5. CONNECTOR UNMATING
DANGER
To reduce risk of electric shock, DISCONNECT the
electrical supply before unmating the connectors
STOP
To unmate the connectors, squeeze the release
latches on either side of the plug and pull back until
both connectors separate from each other.
CAUTION
Do NOT pull on wires when unmating the
connectors.
!
6. REPLACEMENT AND REPAIR
The contacts and connectors, are not repairable. DO
NOT use damaged or defective contacts or
connectors. DO NOT remove the wire and re-
terminate contacts.
7. REVISION SUMMARY
Since the previous release of these instructions,
product has been added to Figure 1.
Tape or Clamp
Tape or Clamp
10 [.394] Max
Plug
Receptacle
Figure 8
10 [.394] Max
Rev D
3 of 3