408-10154 Datasheet, PDF (1/3 Pages) TE Connectivity Ltd – These connectors consist of a plug and a receptacle

LIGHT-N-LOK* Connectors
Instruction Sheet
408-10154
13 MAR 12 Rev D
White
Wire
Wire _Black
Wire
Release
Latch
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
Strain-Relief
Plug
Wire
Plug Assembly
Black
Wire
Strain-Relief
Receptacle
White
Wire
Reason for revision are given in Section 7, REVISION
SUMMARY.
2. DESCRIPTION
These connectors consist of a plug and a receptacle.
Customers may order complete cable assemblies
from TE. Refer to the table in Figure 1.
3. ASSEMBLY PROCEDURE
CAUTION
!
In the field, these connectors must be assembled
by a qualified electrician in accordance with
national and local electrical codes and the following
instructions.
Select the proper connector part number for your
production requirements.
When selecting connectors 2008149-[ ], 2008150-[ ],
or 2008152-[ ] refer to the following procedures:
1. Strip wires with 18 AWG solid copper conductors
having a maximum insulation diameter of 2.18 mm
[.086 in.] to the dimensions provided in Figure 2.
Receptacle Assembly
CONNECTOR
PART
NUMBER
2008149-1
2008150-1
2008150-1
2008149-2
2008150-2
2008150-2
DESCRIPTION
3-Position Plug
3-Position Receptacle
Pre-Mated Plug and Receptacle
3-Position Plug (Orange)
3-Position Receptacle (Orange)
Pre-Mated Plug and Receptacle (Orange)
Figure 1
1. INTRODUCTION
This instruction sheet covers the assembly procedures
of LIGHT-N-LOK Connectors 2008149-[ ], 2008150-[ ],
and 2008152-[ ].
NOTE
i
For detailed application requirements, refer to
Application Specification 114-13207.
9.53±0.80 [.375±.031]
Recommended Strip Length
Plug
Connector
Strip
Gage
Insulation
Conductor
Figure 2
2. Insert each stripped wire into an insertion hole in
the back of the plug or receptacle until bottomed.
For field wiring, black and white wires must be
inserted into corresponding holes marked "B" or
"W". This "Wire-Trap Termination" method removes
the need for application termination tooling. See
Figure 3.
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 3