108-2411 Datasheet, PDF (3/6 Pages) TE Connectivity Ltd – MEZALOK* Stacking Connector System

108-2411
Random vibration
Mechanical shock.
Durability.
Mating force.
Unmating force.
Thermal shock.
Humidity/temperature cycling.
MECHANICAL
No discontinuities of 1 microsecond or
longer duration.
See Note.
No discontinuities of 1 microsecond or
longer duration.
See Note.
See Note.
136 Gs times the number of contacts
maximum.
320 position: 260 N average
114 position: 139 N average.
60 position: 70 N average.
13 Gs times the number of contacts
minimum.
ENVIRONMENTAL
See Note.
See Note.
EIA-364-28, with the exception that
frequency and amplitude shall be as
follows:
5 to 100 Hz, PSD increasing at 3
dB/octave;
100 to 1000 Hz, PSD = 0.1 g²/Hz; 1000
to 2000 Hz; PSD decreasing at 6
dB/octave. One hour in each of 3
mutually perpendicular planes.
EIA-364-27, Test Condition G.
Subject mated specimens to 100 Gs
sawtooth shock pulses of 6 milliseconds
duration. Three shocks in each direction
applied along 3 mutually perpendicular
planes, 18 total shocks.
EIA-364-9.
Mate and unmate specimens for 500
cycles at a maximum rate of 475 cycles
per hour.
EIA-364-13, Method A.
Measure force necessary to mate
specimens at a maximum rate of 12.7
mm per minute. Calculate force per
specimen.
EIA-364-13, Method A.
Measure force necessary to unmate
specimens at a maximum rate of 12.7
mm per minute. Calculate force per
specimen.
EIA-364-32.
Subject specimens to the specified
number of cycles (see Figure 2)
between -55 and 125°C with 30 minute
dwells at temperature extremes and 1
minute maximum transition between
temperatures.
EIA-364-31, Method III.
Subject specimens to 10 cycles (10
days) between 25 and 65°C at 80 to
100% RH.
Temperature life.
See Note.
EIA-364-17, Method A, Test Condition
5, Test Time Condition C.
Subject mated specimens to 125°C for
500 hours.
Salt spray.
See Note.
EIA-364-26.
Subject mated specimens to a 5% salt
spray for 48 hours.
Figure 1, end
NOTE
Shall meet visual requirements, show no physical damage, and meet requirements of additional
tests as specified in the Product Qualification and Requalification Test Sequence shown in Figure 2
Rev D
3 of 6