108-2411 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – MEZALOK* Stacking Connector System

Product
Specification
MEZALOK* Stacking Connector System
108-2411
25 FEB 16 Rev D
1. SCOPE
1.1. Content
This specification covers performance, tests and quality requirements for the MEZALOK* Stacking
Connector System consisting of a 60 position, 114 position and 320 position pin and socket, Printed
Circuit Board (PCB) surface mount BGA connectors. The product is available in 10, 12, 15 and 18mm
stack heights.
1.2. Qualification
When tests are performed on the subject product line, procedures specified in Figure 1 shall be used.
All inspections shall be performed using the applicable inspection plan and product drawing.
1.3. Successful qualification testing for the 60 position and 114 position portion of the product line was
completed on 21Dec10. Additional testing was completed on 25May11, 14Dec12, and 12Feb16. The
Qualification Test Report number for this testing is 501-736.
2.
APPLICABLE DOCUMENTS
The following documents form a part of this specification to the extent specified herein. Unless
otherwise specified, the latest edition of the document applies. In the event of conflict between the
requirements of this specification and the product drawing, the product drawing shall take precedence.
In the event of conflict between the requirements of this specification and the referenced documents,
this specification shall take precedence.
2.1. TE Connectivity (TE) Documents
● 114-13279: Application Specification (MEZALOK Stacking PC Board Connectors)
● 501-736: Qualification Test Report (MEZALOK* Stacking Connector System)
2.2. Industry Document
EIA-364: Electrical Connector/Socket Test Procedures Including Environmental Classifications
2.3. Reference Document
109-197: Test Specification (TE Test Specifications vs EIA and IEC Test Methods)
3.
REQUIREMENTS
3.1. Design and Construction
Product shall be of the design, construction and physical dimensions specified on the applicable
product drawing.
3.2. Materials
Materials used in the construction of this product shall be as specified on the applicable product
drawing.
©2016 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
| Indicates Change
This controlled document is subject to change.
For latest revision and Regional Customer Service, visit our website at www.te.com
PRODUCT INFORMATION 1-800-522-6752
1 of 6
*Trademark. TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.