408-4328 Datasheet, PDF (2/4 Pages) TE Connectivity Ltd – Reasons for reissue are provided in Section 7, REVISION SUMMARY.

408- 4328
3.2. Application Tooling
Power for seating tools must be provided by a
machine capable of supplying a downward force of
20 Newtons (N) [5 lb] per contact. 10/20--Ton “H”
Frame Assembly 803880--6 (Customer Manual
409--5567 provides instructions), SM--3 Frame
Assembly 814700--2 (409--5626), or GreenerdG
Frame Assemblies 3A and 3B equipped with Adapter
Kit (408--9027) can be used.
4. SEATING
When setting up equipment to seat connectors, pay
particular attention to the following:
S The seating tool must be matched to the
connector
S The seating tool, connector, and applicator ram
must be properly aligned before cycling the tool
CAUTION
!
If the tool and connector are mismatched or are
improperly aligned, damage could occur to the
tooling, connector, or both.
1. Set seating height to the dimension shown in
Figure 2 (applicator shut height will equal the
seating height PLUS the combined thicknesses of
the pc board and pc board support).
2. Position connector onto pc board so that the
connector contacts are properly aligned to the pc
board and pc board support fixture.
3. Insert connector into pc board until the contacts
are resting securely on, but have not fully entered,
the board.
4. Position the seating tool on the connector,
making sure that the tool is bottomed on the
housing floor.
5. Center the seating tool and connector under the
applicator ram of the tool. Lower the ram slowly
until it just meets the seating tool. Verify alignment
of pc board support, pc board, connector, and
seating tool.
CAUTION
!
Damage to the pc board, seating tool, or
connector may occur if seating height is
improperly set or if tool is not properly seated in
the connector before cycling the tool.
6. Cycle the tool to seat the connector in the pc
board. Then retract the ram and carefully remove
the seating tool. Check assembly for proper
seating according to Application Specification
114--6061.
7. Repeat Steps 2 through 6 until all the
connectors are seated.
View After Seating
Applicator Ram
(Fully Down)
Seating Tool Centered
Under Applicator Ram and
Bottomed on Connector
Seating Height
(Connector Seated)
38.1+0.25/- 0.00 mm
Applicator
[1.50+.010/- .000 in.]
Shut Height
(Ram Fully Down)
(See Section 4, Step 1)
Connector Contacts Inserted
into Holes in PC Board and
PC Board Support Fixture
PC Board
Note: Not to Scale
G Trademark of Greenerd Press & Machine Co., Inc.
Figure 2
PC Board Support
Fixture (Ref)
2 of 4
Rev C