408-4328 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Reasons for reissue are provided in Section 7, REVISION SUMMARY.

Seating Tool Assemblies 1320142- [ ] and 356198- [ ]
For CHAMP* .050 Series I Blindmate Press- Fit
Connectors with Compliant Pin Contacts
Instruction Sheet
408- 4328
28 APR 11 Rev C
Seating Tool
Assembly
356198- 1 (Ref)
Compliant Pin Contact
(Board Retention Feature)
CHAMP .050 Series I
Blindmate Press- Fit
Vertical Receptacle
Connector (Ref)
SEATING
TOOL
1320142--1
1320142--2
356198--1
356198--2
356198--3
NO. OF
CONNECTOR
ROWS
CONNECTOR
TYPE
40
Extended
Height
80
Press--Fit
80
40
Press--Fit
20
Figure 1
PC (Printed
Circuit) Board
(Ref)
PC Board Support
Fixture (Ref)
1. INTRODUCTION
Seating Tool Assemblies 1320142--[ ] and 356198--[ ]
are designed to seat CHAMP .050 Series I Blindmate
press--fit and extended height press--fit vertical
receptacle connectors. The connectors contain
compliant pin contacts to allow solderless pc board
installation. Each seating tool is specifically designed
for the number of rows in a connector. See Figure 1.
Read these instructions and understand them before
using the seating tool.
NOTE
i
Dimensions on this sheet are in metric units [with
U.S. customary units in brackets]. Figures are not
drawn to scale.
Reasons for reissue are provided in Section 7,
REVISION SUMMARY.
2. DESCRIPTION
During seating, the seating tool covers the connector
and presses on the top surface of the connector when
the applicator ram applies force to the seating tool.
The pc board is positioned onto a pc board support
fixture for support.
3. REQUIREMENTS
3.1. PC Board Support Fixture (Customer Supplied)
A pc board support must be used to provide proper
support for the pc board and alignment of the seating
tool to the contacts, and to protect the pc board and
and connector from damage. The board support
fixture must be designed for specific needs using the
recommendations in Instruction Sheet 408--6927.
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1--800--722--1111 This controlled document is subject to change.
PRODUCT INFORMATION 1--800--522--6752
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 4
LOC B