408-10389 Datasheet, PDF (2/19 Pages) TE Connectivity Ltd – Ocean Side-Feed Applicators

Air Feed Applicator
Feed Cam
Retract Speed Control _{Air Supply}
Forward Speed Control
Connection
Feed Stroke/Feed
Forward Position
Adjustment
Feed Back Stroke/Rear
Position Adjustment
End Cap Bolt
(2 Places)
408-10389
Feed Pawl
End Cap
Detent Screw (2 Places)
Mounting Screw (2 Places)
Air Feed Housing
Marking
Feed Arm
Feed Pawl Holder
Figure 2
Each applicator is individually designed for specific terminals. The wire crimp height and insulation crimp height
can be adjusted to accommodate different wire sizes and insulation ranges, respectively. The applicator is also
designed to accept modular-feed packages. The feeder assembly can be removed from the applicator and
replaced with any different style: mechanical feed, air feed, or servo feed, depending on the requirements. See
Figure 3. To change to a different feed type, use retro-fit kit 2119949 for the mechanical terminal feeder, retro-
fit kit 2119950 for the pneumatic terminal feeder, and retro-fit kit 2119951 for the servo terminal feeder.
Changing Feeder Assembly
Servo Terminal
Feeder Assembly
Servo Feeder Latch Plate
Pneumatic Terminal
Feeder Assembly
Mechanical Terminal
Feeder Assembly
Push Rod
Bushing
Applicator
Rev M2
Figure 3
2 of 19