408-10389 Datasheet, PDF (15/19 Pages) TE Connectivity Ltd – Ocean Side-Feed Applicators

408-10389
1. Turn the drag release lever upward, raise the feed pawl, and pull the strip back so that the lead
terminal is between the strip guides.
Setup for Carrier Strip Cut or No-Cut
Carrier Strip Cutting Blade
Storage Locations for
Non-Cutting Configuration
See Detail A
Carrier Strip Scrap
Cut Configuration
Cutting Edge
Counter Setscrew
See Detail B
Detail A
Carrier Strip Scrap
No-Cut Configuration
Detail B
Applicator Counter
Carrier Strip Scrap
Cut Configuration
Carrier Strip Scrap
No-Cut Configuration
Figure 9
2. Push down on the floating shear, then remove the shear retaining screw from the side of the shear
holder.
3. Slowly release pressure on the floating shear. The compression spring will push it out of the shear
holder.
4. After removing the floating shear, lift the compression spring out of the shear holder.
5. Inspect the spring for damage, and replace it if necessary. Refer to the applicator parts list for the part
number.
6. Re-install the floating shear(s) using the reverse of the installation procedure. If installing a new shear,
make sure that the part number is on the applicator parts list.
7. Raise the feed pawl and move the lead terminal over the anvil. Turn the drag release lever down to
lower the stock drag.
8. Check the shear holder adjustment as described in Paragraph 5.6, Shear(s) and Shear Holder(s)
Adjustment.
Rev M2
15 of 19