CLLE1AX7S0G225M-0.95 Datasheet, PDF (8/13 Pages) TDK Electronics – Ultra Low Inductance Capacitors

General
Specifications
CLL Series – ULI Capacitors
No. Item
Performance
12
Moisture Resistance (Steady State)
External
appearance
No mechanical damage.
Capacitance
Characteristics
X7R
X7S
Change from the
value before test
± 12.5 %
D.F. (Class 2)
Characteristics:
X7R: 200% of initial spec. max.
X7S: 200% of initial spec. max.
Insulation
Resistance
10MΩ·μF min.
13
Moisture Resistance
External
appearance
Capacitance
No mechanical damage.
Characteristics
X7R
X7S
Change from the
value before test
± 12.5 %
D.F. (Class 2)
Characteristics
X7R: 200% of initial spec. max.
X7S: 200% of initial spec. max.
Insulation
Resistance
5MΩ·μF min.
14
Life
External
appearance
Capacitance
D.F. (Class 2)
Insulation
Resistance
No mechanical damage.
Characteristics
X7R
X7S
Change from the
value before test
± 15 %
Characteristics
X7R: 200% of initial spec. max.
X7S: 200% of initial spec. max.
10MΩ·μF min.
Test or Inspection Method
Reflow solder the capacitor on P.C. board (shown in
Appendix 1 and 2) before testing.
Leave at temperature 40±2ºC and 90 to 95%RH for
500 +24,0h.
Leave the capacitor in ambient condition for 24±2h
before measurement.
Reflow solder the capacitors on P.C. board (shown in
Appendix 1 and 2) before testing.
Apply the rated voltage at temperature 40±2ºC and 90
to 95%RH for 500 +24,0h.
Charge/discharge current shall not exceed 50mA.
Leave the capacitor in ambient conditions for 48±4h
before measurement.
Voltage conditioning:
Voltage treat the capacitors under testing temperature
and voltage for 1 hour.
Leave the capacitors in ambient condition for 24±2h
before measurement.
Use this measurement for initial value.
Reflow solder the capacitor on P.C. board (shown in
Appendix 1 and 2) before testing.
Apply 1 x rated voltage at 125±2ºC for 1,000 +48, 0h.
Charge/discharge current shall not exceed 50mA.
Leave the capacitors in ambient condition for 24±2h
before measurement.
Voltage conditioning:
Voltage treat the capacitor under testing temperature
and voltage for 1 hour.
Leave the capacitor in ambient conditions for 48±4h
before measurement.
Use this measurement for initial value.
TDK MLCC US Catalog
Page 236
Version B11